Search:

Yep

I think jerseybigfoot?s spacer idea and msafi65?s heavy washer fix together with blue lock tight should fix your problem. I would also make sure the belt alignment is such that it is not putting...

Pull the right shifting collar out and see if the pin in the bottom is worn.

The shaft is short so the clutch can be removed without pulling the tranny. It is a hardened shaft and comes in a one length only. Something is causing your clutch to come loose. Bent or worn input...

With the shaft play and plungers sticking out of the case is evidence of wear of the bands and thrush washers. You really don’t know how bad it is unless you pop it apart and inspect it, which is...

Congratulations to the Kenyon racing team for winning three national championships! Talk about keeping it in the family! Congratulations to Nick Oxender For winning the Springer championship his...

I’ll be there with my 4 stroke.

I’ll be bringing theses two JLO’s to Ashtabula next week. The 400 runs but has noisy crank bearings. The 340 has good cylinders, mag and starter motor. $75 or Best offer takes them.

There are some transmissions out there that were prone to band stretching. Not sure if it was an alloy or tempering problem. I had a bunch relined and some where still too long because they were...

Time to get that springer done!

Anyone know the ac output voltage for the 484 chaparral lighting coil?

That’s an old one Andy, back when men were men, no roll bars!

Omg! A 600 on a Baker hill!

And a springer!

Sounds like your secondary clutch is turning when at idle. This can be from your belt being a hair too tight, belt too wide, clutches out of alignment, or idle set at primary clutch engagement rpm....

Would help if you could put up a pic of the inside of machine showing the transmission plungers and what engine you have.

Supermod winners

Thanks to Buddy and crew and Dave G for a great racing weekend. Not a single machine had to be towed off the track!

Do you know if George or Jim are going to make it for 4 stroke?

Brad, Rick, and I should be there early Friday afternoon.