Search:

Sorry 900 miles, not hours.

Got inner bearing off and axle removed without any damage. I used a 3/8” bolt and drilled a small divot in the top of bolt then threaded it into thrust bolt location. A quality 3 armed pulley puller...

Thanks for the quick reply. There was two holes for set screws which were empty. I read a service bulletin/instruction from Argo that later models no longer use the set screws, so I assume that why...

Outer wheel bearing fell apart on my 2018 Argo Avenger hunt master. 2nd from the front on the driver side. I nearly have the axle out but can?t seem to get the inner bearing off to pass thru the...

You could try using an automotive 12V test light. Check for power at the starter solenoid post when you turn the key. (One post always has power, other post has power when key switch is turned) If...

That is good advice, I will try that before I pull the starter out just in case. Thanks.

My new to me 2018 avenger 8x8 hunt master has issues starting. (30hp Kohler ELH775 motor) I have narrowed the problem down to the starter solenoid. The original complete starter with solenoid itself...