jpnewby
Registered Rider

How did you make out with your plow mounts?

check out my pics on here. I made two plows for max II and max IV. Each plow uses two bolts drilled for a push type cotter pin for quick detachment,works really well. One pic shows the home made mount on the max II front bearing bolts, had to use longer bolts. Max iv had bearing cages which made it alot easier to get at and fab a mount. I wish I could come up with a way to angle the plow from the seat also. A friend made a cable system for his plow on his tractor. A choke cable to pull the release pin and two more on each side for direction. Primitive but works with little effort as long as plow is off the ground. Brake line for cables to ride in and mount s to dash with one hole straps.