I had the very same problem with my 2000 bigfoot . 18 hores briggs , check that the small rubber seal on the dipstick is in fact making a seal when you push the dip stick all the way in ,there should...
Type: Posts; User: Robert
I had the very same problem with my 2000 bigfoot . 18 hores briggs , check that the small rubber seal on the dipstick is in fact making a seal when you push the dip stick all the way in ,there should...
I have a 2000 bigfoot with 25" runamucks and I am want to install some 13" used tracks that I bought .
The question I have is, I know I have to replace the tires with smaller tires {probably 22"...
I have a set of 13" plastic tracks for my 6x6 bigfoot and was wondering before I go to the trubble of trying to fit them on my Argo and buying tires, how well do they work in soft powdery snow ? I...
I recently bought a set of used 13" tracks for my 2000 Bigfoot, but the Bigfoot has 25x12x9 tires on it. It dosn't look like they will fit the tires and there would not be very much clearence between...
I got insured with state farm in Barrie with no problems .I already have insurance with them for my cars so they added the argo
I have an Argo 6x6 with the rawhide tires an I was wondering which way the v pattern on the tires should face, should the center v point face forwards or should it face backwards , or does it matter...
Thanks for replying everyone,I found the problem ,when I did the valve adjustment one of the valve cover gaskets was not in sitting properly and was leaking air into the crankcase causing a positive...
Thanks for getting back I checked the stick and it is at half on the stick I took the oil fill cap off and i can feel air pulsing out of the hole when it is idleing , it didnt do this before i...
Hello I have a 2000 bigfoot with an 18 hp Briggs and stratten and I just did an oil change set the valves and rebuilt the carb and now when I start it it seems to pump oil up the breather tube into...
Thanks for getting back to me Rock Doctor,If I change to the new bearings what part numbers would I use to order the parts ? Bearings ? Gaskets ? Housings?
thanks Rob
Thanks Roger for getting back to me , i will just clean and lubricate the shaft and make shure that the sprockets move freely on the shafts,also It sounds like I should just replace the stock...
I just watched the vid about converting a conquest from regular bearings to hdi bearings and was wondering ,can I convert my 2000 bigfoot to hdi bearings?
I have to replace 4 outer bearings anyway...
I have a 2000 Bigfoot and when I was cleaning under floor pans I noticed that both of the dubble idler sprockets are floating and there are no set screws in the flanges:hmmmm2:,is this normal ? or...
Angus here
Hi everyone Just got my first argo 2000 bigfoot and I am getting exited tinkering cleaning and adjusting getting it ready. I live in Angus Ontario Canada and have a cottage in Muskoka . I hope to use...