Hey Curtis, use an aerosol brake cleaner or electronic degreaseing spray. Should be available at any parts store
Type: Posts; User: rapidroy
Hey Curtis, use an aerosol brake cleaner or electronic degreaseing spray. Should be available at any parts store
Hey buddy, one old goat to another here, you mentioned going through the fuel system when you first acquired the machine.
Did you perhaps change the fuel pump? These are relatively low pressure...
Hello Lithail, you can tie the sides together with the bars for your bottom seat bracket, just use heavy wall tubing rather than the stock thin wall tubing. I did this to cure body sag on an older...
Since the upper body is off you might want to straighten the square tubing under the seat that holds up the outer body shell. That will take care of your sag in the middle. It doesn't appear too bad...
You can't raise the tranny high enough without removing both primary drive chains
Curtis you have to remove both primary chains to get the motor plate high enough to clear those lower sprockets. Don't forget to loosen the center bolt on the motor plate, failing to do so you risk...
Do a compression test to make sure the cylinders have equal pressure, if they vary, check the push rods.
The best bet is to check out the videos on this site, I perused many many videos of all sorts until I made my mind up of what I thought would suit my needs. I selected channel type elevated belt for...
Alaska snow machine salvage does small engine repair and they are down near All seasons argo. 800-679-7669
That clutch is threaded on the shaft, righty tighty, lefty loosey. Lots easier if the engine is out of the machine, put a wrench on it and give it a good wack. // RR
Mine came from Adair, I believe they developed them. You need to call for a quote...
Good solution Jim, is the deck removable? Appears the expanded steel keeps the tires from wandering.
RR
My conquest has a single chain link welded to the center of the corner axles, works okay if you cross the straps back to front and front to back. It tends to move a little side to side. Whatever you...
The 2004 conquest had the t bar steering, parts should be available. RR
Good morning Curtis, your machine will take a long time warm up at idle speed which is around 650-700 rpm. Try a higher idle speed, around 1200-1300 rpm with the choke pulled out a little to richen...
http://www.6x6world.com/gallery/data/503/medium/argo_ice_fishing_resized.jpg
Here is a pic of my ice auger carrier, need a more compact unit like yours. Gas always leaks on everything in the...
So what brand is the actual holder? Nice job on the bracket, looks good and functional. Thanks for the feed back. // RR
Hello Sol, nice machine you got. Any chance of seeing a pic of the auger mount on the rear of your rig? Thanks /// RR
[QUOTE=mikethered;195098] Mcmaster didn't have belting my size. they did have 3", which is my width but nothing thick enough, mine are 1/4" thick. Any other ideas on where to find belting? QUOTE]...
The key switch grounds the ignition to stop the engine. The magneto coil does not need an external power source to run, so the connector plug to the engine wiring harness is loose or the ground wire...