Part number has just been released. Part # 607-212 and it's less expensive than the old muffler.
Type: Posts; User: Howie
Part number has just been released. Part # 607-212 and it's less expensive than the old muffler.
Service bulletin SB204 has instructions for re-calibrating the LCD gauge. If that doesn't work get a new gauge, part # 613-130 and see if your dealer can submit a warranty claim.
Call your Argo dealer and ask them to e mail a copy of service bulletin SB229. This likely addresses your check engine light not functioning.
Argo makes a fuel can carrier accessory, part # 867-01. Check it out.
Make sure your intake duct is tightly sealing against the air intake screen. If there are any gaps, hot air in the engine compartment will be recirculated over and over. If there is a gap ypu can...
Center to center distance on a Conquest is 15.35"
One more pic (same engine) The head gasket leaks compression into this area on the engine block and creates a positive pressure in the crankcase which will blow oil up through the breather reed and...
At this point I would pull the heads off. # 2 cylinder (closest to the firewall) tend to run a little hotter as there is less coll air circulation back there. Have a look at the attached photo, I'm...
Couple of questions...? Do you have the original continuous loop tracks (1 piece)? If so you might benefit from installing an 825-55 Hinge kit. Also, an 04 Avenger was built with 12 tooth 606-35...
No Tecumseh powered I/C's were manufactured,.......however here's the breakdown of models: Model T = 6 wheel standard
...
When you look at the engine photo you'll notice the ignition coil is externally mounted to the engine. This identifies the engine as a KT17 not a Magnum. KT17 is 12 volt battery ignition with points...
You can obtain the VIN information from your dealer if you get the serial number that is stamped in the top of the transmission case. That of course is if it's the original transmission.
You're correct RD. Sorry for the confusion, for some reason I thought he was upgrading an Avenger. The bearing extensions only need to be replaced if you have a vehicle with the 810-91 extensions...
Hi Pinz. Have your dealer print a copy of parts bulletin # 161. This contains all the part numbers you will need along with the installation instructions. You will also need part # 658-58 routing...
84558455Hi Pinz. Glad that helped. Sorry for not replying sooner, been pretty busy. I've extracted page 30 from the current operators manual. Give it a try and let me know how it works out.
Page 30 of the current operators manual explains how to adjust your secondary clutch for belt wear. It can be done right on the machine without removing the clutch. The HD belt is much more...
When the front chain tensioners were eliminated, the front axle locations were moved forward by 1/16". Removing the front chain tensioners will leave too much slack in the chain. The chain...
Hi.
Hypoy C is just a brand name from Castrol. Any good quality 80 W 90 gear oil is acceptable.