Sold my argo guys, Loved it, and put alot of work into it, but just don't use it like I thought i would. ATV is more practical for me as all of my points of destinations to get to are too far to...
Type: Posts; User: mike bar
Sold my argo guys, Loved it, and put alot of work into it, but just don't use it like I thought i would. ATV is more practical for me as all of my points of destinations to get to are too far to...
are the shafts the same sizes??
does it sit in neutral and idle alot? my only explanation for a bad bearing up there. Is there any play in it?
My gut feeling is -- It's in rough shape. No gas cap and sitting outside for starters. lots of hours so i'm only guessing the tranny should be gone over, if not it will probably end up like mine did,...
I'm with Mike on this one. Take the starter off and find out what is really goiong on. Bench testing is much easier. At least you'll find out what that wire is for.
That's one big kitty!! Great vids. as usual RD
I got a lead on two different cars. each want $200 for the whole car. They aren't going anywhere to soon because the frames are bad.I am just in the planning stages right now until the weater warms...
One more big Question. Is there enough room in the magnum to house this puppy? I don't mind building a new hood but not to keen on cutting the tub to bits. My brother seems stoked to get on with...
well i guess you (BROKE THE ICE) on your maiden voyage:laugh: I know that feeling and it's still a shocker.
I don't even know what size my clutch shaft is yet, but i will measure it before i talk to machinest.I assume from you guys that either 1" or 1 1/8" will work? When i talk to the machinest what are...
I have to admit, the earth would probably come to an end by the time i would get her figured out. My brother said he would be willing to help out. He is more mechanicly inclined than me and has done...
Ok guys,to be short and sweet, I have a 18 magnum which is getting weak and has a hard job pushing the supertracks. The govenor was unhooked when i got it and not quite sure if it has anything to do...
try adjusting the waserlike thing on the ajustment linkage, it has a hex screw in the side of it. when the brake fluid warms it swells and if this washer like thing has nowhere to go it applies...
Hi shizzles, welcome to the site. The front section of chain has no way to adjust other than replace the chain. the other sections work off spring loaded tensioners which tend to get weak as they are...
Don't let the thoughts of it get to you. It is actually quite easy. Jack the buggy up and unhook the masterlink and pull it out. Reinstall using a piece of haywire to feed it through underneath and...
Lexan would be my choice only because it will probably take more abusethan safety glass.
It say's in my manual that with the wheels off the ground on the side you are checking and by grabbing the chain between the sprockets at mid point on the top side you should not have more than...
I have a magnum. there are none for mine. I assume yours is the same
Hi guys, its been a while since i've been on here. I had to put my 2 cents in here about the magnum as i have one. They are a great motor but mine does not like warm days as it heats easy. I might...
Try new plugs. I have seen it happen before. also the air filter may be plugged.