Search:

Nothing big this time, just a couple of slider blocks and the usual oil change, fuel filter change, air filter check and clean, greasing, etc. The only thing I noticed was one brake pad seems like...

I'm with Bob on the gears. I run an 07 Avenger and am usually in high gear, unless I'm on a steep hill, heavy loads, deep snow, or thick mud. Lately I've found that I don't need the tracks as much...

Why do that? Personally my Avenger has been off the tires in the garage twice in 15 years, when I was working on it. Otherwise I drive it into the garage, put a cover on it, and it waits for its...

My 07 Avenger has a 4,500# Rule on it. So far all I've had to replace was the cable and rollers on the fairlead. If it fails, I'll be staying with a 4,500# again.

As the manual says they should be 20-11-8's, then that's what I'd run. I think ivecread that the paddles do help marginally for the Argo's "swimming" ability. As for the tread type, I'd look at...

I had my tracks set-up on my 07 years ago by the dealer, and they followed the procedure in the manual on how to do it. I would guess that too much air pressure is harder on the machine. Track...

With tracks, your tires will need to be the same circumference at a pressure. For example mine are 3. 5, 5 and 4 psi on the one side, I think. It has to do with chain wind-up and driving them all...

I tried to get my 8x8 across a river with the tracks on, and it wouldn't get much momentum. A buddy wound up pulling it across and compared it to a float plane. I always have my tracks on, as it's...

I'm not sure what the plan for a heater would be. Electric heat? 3 mile extension cord? Generator in the back with a cord to keep it running?

I'm guessing the range will drop significantly if it had tracks on it, or it was below zero out or if you happen to get stuck and need to use the winch.. Guess hunters and other outdoor enthusiasts...

I will grease it every 2-3 days when we're out with the machine and more if needed. It all depends on what kind of terrain I'm in. Grease is cheap. Bearring failure can add up quick, if the shafts...

Staying on top of the maintenance is key to keeping your machine reliable and extending the longevity of it. My argo is an 07 Avenger and before I head out, I give it a quick once over to make sure...

Maybe 7 years ago that was the price?

When mine acted up, the quick connect on the wiring to the fan had come apart. Is your connection solid?

I added a 12" extension hose on mine and it makes it a little easier doing the outer ones without tearing the wheels off.

I run an '07 with tracks on about 98% of the time and the few times I've been in the snow has been in high range with no issues.

I did mine last fall, and it's some work, but as ArgoJim mentioned, it was all done in place. Whoever designed the machine must have had to work on them in the past, since it looks like pretty close...

When I have replaced mine, I went to NAPA and got their HD Agri chain. Seems to be working out well! Don't cheap out, though. I had one box that wasn't HD and wound up replacing those ones last...

Loose or missing fuse? My '07 didn't start one morning while out hunting. When we looked at it, we saw one fuse had fallen out. Replaced it and it fired up right away. Pushed them all back in to...

14" diameter allen screw?! That's huge! I am guessing you are saying 1/4".. If they didn't have a bearing on them, I'd guess at a set screw from a sprocket. Depending on where you found them,...