Search:

Had the same concern last year when I bought my 2021 Aurora 950. It was the same as my 2011 HDi so I was able to move my tracks over no issues.

The alternator kit is expensive but I noticed a difference. You don’t want to be worrying about draining your battery.

I have one for my Bigfoot I Like it. The only problem I have with it is it leaks at the middle seem. I have not tried to seem seal it with silicone and mineral spirits yet but plan to. It is stout...

Cut angle iron pieces the length of the bed drill holes for straps. Bolt each to the mold rail of the tub and you are set

Baxtera,
You have to remove the firewall and reach in to it. There isn't much else to remove. It's tight but you can do it.

I believe you need to loosen the back base bolt and top support pry up and tighten then adjust on the front

Don't over tighten and make sure to inspect the teeth. I let one go too long and tore my teeth up had to replace the rotor. Then I over tightened and I think it caused my granny bearing to go out....

Looks good. I just installed a battery tender terminal on my battery any feed it through a hole Indrilled in the cover. I can't believe I never had one before! It took almost three days to top off...

You can just add a batter cutoff switch under the seat. They are cheap on Amazon with the cable kit and take less than an hour to install. You can also get them at the dealer but you will spend $70...

I just got a set but haven't used them. They are well built and ship in flat rate boxes so it good For us AK folks

Do you have track tuners?

Great looking set up! How do the rubber tracks feel with the new EFI turning them?

How are you bending your Chanel? Are you done?

1306913070
This is the size I just installed in my HDI. It is a tight fit but works. Hope that helps you.

What do you have?

Thanks Nubs. $195 is a spendy belt but if it works I will stick with it.

I put a yellow top in my bigfoot and it has worked great. I will upgrade my 2011 HDi when needed. They are proud of them though.

Anyone try the aftermarket HD belts from Amazon or ebay? I am looking for a spare for my HDI but wanted to hear any reviews if any. Thanks

I would take a look at the brakes. Sounds like one is dragging causing it to pull. The noise you hear is most likely the chain tensioner. It's easy to check and adjust. The other thing to look at...

http://www.6x6world.com/forums/argo-atvs/11550-argo-meat-wagon.html?highlight=Meat+wagon

This is a thread for one I made. It floats good and hauls heavy loads smooth.