Do your repairs before it turns into a major, i have never a had my machine leave me stranded in the bush, i do my repairs before i go out.
How long will they last, well that depends on the owner,...
Type: Posts; User: jimsummit
Do your repairs before it turns into a major, i have never a had my machine leave me stranded in the bush, i do my repairs before i go out.
How long will they last, well that depends on the owner,...
I guess i have been lucky, on my 3 rd machine and no big deal to keep up on maintenance. I wrench for a living on large construction equipment down to small water pumps and I don’t find argos any...
I had the same issue on my 750 Efi, it was the fuse not connecting in the fuse block.
10x7 will work best but only up to hull speed, whick seems you are at already.
Of the machines i have had in my shop a few had over 10,000kms @ 1000hrs with rubber tracks, well over 75% lug left on them.
The guides wear thin but the rubber keeps going.
Excellent, as the snow gets deeper you might want tracks for it.
Looking forward to more.
I guess Outfitting with that amount of use.
No broken stuff in part by the Adair tracks cause less stress on axles and chains?
Thats what i have found thus far, the Adairs spin freely vs rubber...
The fasteners break when the tire guide catches on a log thru tight trails. The top part of the track is going forward and if it catch on sawed off logs at track hight it twist the guide breaking the...
Clean the main jet, if it runs with choke that means the fuel is getting into the carb.
You can remove the jet by first removing the shut off solinod, then insert a flat screw driver into the hole...
I made a canopy by mounting a loop behind the seat same height as the windshield. Cover snaps to the windshield and goes over the loop bar and can tie it to the rear to cover my load or straight down...
I like the higher speed, my conquest hits 32km hr and on hard ground i would like more. The lower geared avenger would seem very slow.
I left the primary on the engine, just removed the big nut 1 5/16", and the outside cover comes off with the 3 weights. The spring stays under tension inside the rest of the clutch. Makes it real...
That looks real nice bigred.
My conquest runs 18" supertracks and the med geared trans, which amounts to an under powered argo. I tightened up the secondary spring to #1 hole which helps, added a spacer in the primary clutch...
Interesting, mine was a 1996 so argo must have changed it the next year.
The Bigfoot has a slightly longer wheel base, couple inches to make room for the 25" tires.
Just a follow up, the charging system fuse is a 30 amp. No more issues with charging now.
No alt, i only need to know what amp fuse goes in the inline fuse holder.
Stock system is working fine, but don't want to install to large of a fuse.
Working on a 2007 750 Efi and the main fuse for the charging system is missing and i can not find any info on what amp fuse it should be. It's mounted in front of the engine, not part of the fuse...
To the guys that find the trans too loud, it cost me approx $600 to replace the gears in my conquest and now there is no whining or howling at all!
If you only replace the bearings and seals, the...