The idle mixture screw really only affects the mixture at idle. A dirty air filter will cause it to run rich also . The carb sounds like it will need a good clean as it has a number of air jets that...
Type: Posts; User: AussieMax
The idle mixture screw really only affects the mixture at idle. A dirty air filter will cause it to run rich also . The carb sounds like it will need a good clean as it has a number of air jets that...
You might need heavier weights or lighter springs on the primary. If the weight is too light it will shift off early. Does it reach full speed of the trail? It sounds more like clutch setup rather...
http://www.6x6world.com/gallery/data/502/thumbs/image619.jpg
Here is a pic of the engine bay, it's not great but it will give you an idea. It is mounted on the original engine frame that I...
http://www.6x6world.com/gallery/data/502/thumbs/image620.jpg
Here is a pic
Hi,
I have a buffalo truck with a kubota diesel in it. I put a 3 cylinder d660 in it a while ago, I also added a turbo. The only 2 problems I have had was getting it to run cool firstly, and getting...
The 2 yellow wires go to the stator under the flywheel, and the red needs to go to the battery. If it isn't hooked up it won't charge.
The Kohler is better in that it is still produced and parts are readily available. A Kohler or Briggs would be a good choice.
Hello All,
The springer arrived a while ago, and it is a truly awesome machine! I have been travelling quite a lot since it arrived and haven't had much time to dirty it yet. I'll be back home in a...
We've had a Buffalo truck for over 4 years now and we think it is a very good machine. They swim as fast as a Max IV with the 26" tyres and are more than capable in the rough stuff. I think the tray...
On the top of the carb there are 2 brass screws that screw in at an angle. If you remove them, they look a bit like a jet. There is a small hole in the underside of them that blocks easily. Clean...
I think you are correct about the different springs in the kit. They should be different colours to indicate different tensions. Changing to a firmer spring will lean it out. The other thing to look...
I think it's interesting how when the first Mudd-Ox's had some heat issues causing hot start problems a lot of people made noise on here about how they wouldn't own one until every issue was fixed,...
Just a question, but isn't the footbrake useful for descending hills? How would you go about this with a handbrake only? I find in really steep country the footbrake is perfect for applying even...
Hi Alberto.
A full fuel tank should last for around 9 hours of use. When you use it in water you may get a small amount of water inside the tub, but that is fairly normal. You may get some water...
If that rotation is anticlockwise when facing the flywheel, then it is running backwards to a normal engine. Generators usually run a tapered output shaft as gearhead said, and it may make finding a...
I think some people are getting confused here as to what an owners manual is. In my experience an owners manual only covers basic operation of the machine and describes the controls etc. Some basic...
I agree with Jersey. Hydraulic brakes should self adjust. The only way you would have problems is if the piston in the master cylinder is adjusted so it can't return fully allowing the fill port to...
Nice going. It looks like a bought one.
The high altitude jet kit has smaller jets than standard. If it was going to be a problem it would run too lean, so if anything you would need more choke not less. I'm not that familiar with the...
Changing the engine mountings shouldn't be that hard. The Kohler engine would be worth the time and effort.