I got my gx620 engine installed but now got a new problem. I had to space the engine further forward to clear oil filter and need a longer belt. Anyone know where to order belts from? I need 1-3/16?c...
Type: Posts; User: edrk213
I got my gx620 engine installed but now got a new problem. I had to space the engine further forward to clear oil filter and need a longer belt. Anyone know where to order belts from? I need 1-3/16?c...
Thanks Noel, I will try them. Not sure why this engine is 1-1/8, the ones I saw online were 1 inch, maybe cause it’s a clone?
I haven?t worked on my Argo for awhile but I recently bought a used 620-20hp vtwin but it has a 1-1/8in shaft. Does anyone know where I might get a 1-1/8 bore clutch that will work and also any tips...
Don’t really want more power just something reliable. Can’t get the old tec to run properly and I have tried everything so I’m done playing it’s coming out. Maybe try rebuilding later but for now I...
Thanks NCT, was afraid of that, guess I’ll have to spendy more and get the twins!
I have an 82 Argo with a Tecumseh 16hp that I want to replace with a 420cc engine from Princess Auto. Would this have enough torque to power a 6x6? Thanks
Hi, I need a 16T reverse idler gear from 1982 6x6 Argo transmission. The trans is model # 6268J with hi and low. The argo is model HT 4898.
Thanks.
I got it apart and you’re right it was tough just used a bigger hammer. Yes everything is a press fit holding the cover on. It was just a rusted double gear and splined shaft. I cleaned it up and now...
I got every seal and snap ring off I can see on the outside of the trans but nothing is moving. I’ve hammered and pryed as much as I want to, what do I do now do I need to use a press? The manual is...
Can anyone recommend a good snap ring pliers to use on these transmissions? I think the biggest snap ring is almost 2-1/2 inches. I bought a ‘heavy duty’ channel lock set that failed already. Thanks!
Got the secondary off, it was tough. Taking a break then tearing into the trans.
Well I did what you suggested, and thanks for the help by the way cause it was working. I got the clutch moving about a 1/4 inch and then the bolt broke off in the input shaft. I decided to use a...
My argo trans is stuck in hi gear and I need to take the transmission apart. I got it like this and it was probably sitting outside for a few years cause there was some water in the gear oil. I...
I just got my first Argo 6x6. It has a Tecumseh OH160 and I think it’s a 1979. It needs some work but I was expecting that. Also I picked up a parts Argo that is about the same vintage . Hopefully...