Well I ended up pulling and cleaning the carb, it looked like some varnish was starting to build up. Once that was done I didn't have any spark. I felt like an idiot when I found a wiring harness...
Type: Posts; User: Canvasback
Well I ended up pulling and cleaning the carb, it looked like some varnish was starting to build up. Once that was done I didn't have any spark. I felt like an idiot when I found a wiring harness...
Well I pulled the carb and cleaned out all the jets. Got a new fuel shut off solenoid and installed it as well. Dropped the solenoid copper gasket and when I screwed it down it would not move. I...
I have plenty of fuel flow. I think that it is filling up the bowl but not leaving the bowl. Acts like it's flooding but not leaving the bowl to ignite. I'm going to pull the top off and try to clean...
Can you trim off the needle on the fuel shut off solenoid to far and overflow the carb? That is what it's acting like, way to much fuel.
I have done some extensive searching on here to find my problem but I'm stuck. Pulled out my Conquest to fire it up tire pressure check etc. would not fire. Turns over good but it acted like it...
Not sure what time I can get these guys moving. Hopefully I can be there around 9-10am Saturday
I'll be there on Saturday for a few hours. Also bringing a coworker with a Polaris Ranger. How will I get in touch with y'all once I'm there?
Will do Jim and thanks!
I should be able to make it. Luckily that's the weekend before turkey season!
Thanks Argojim! I use mine for hunting and don't plan on getting into big water when I go out. I'm new to the Argo world so I wasn't sure. I primarily duck hunt so mud muck and swamp are my main...
I have had it in the water without the tracks and ROPS and it did great. My Argo came from PA so lots of snow and supertracks. Not impressed
I found out this week that Busco is in NC. I just moved up here! When do you go? My friends and I looked it up. I want to check it out
I had a question for you guys. The Argo Manual says to not run the axle extensions if you do not have the tracks installed. Is this an issue or do I need to take them off without the tracks? I have a...
Finally got that broken bolt out! After rebuilding the brakes the levers move down smooth now. So much better to drive!
I'm down in NC and usually no one has ever seen an Argo. If they have they do say the same things. You have to wrench on it for 8 hours to drive it for 2. When they say these things I ask them if...
I finally got around to getting this work done. I installed the alternator kit new throttle cable, and rebuilt the entire brake system. ArgoJim, you were right. The bushing was full of gunk. I...
I haven't had a chance to dig into it yet. I did by some new brake fluid. I figured I would order the o-rings to rebuild the master cylinders and calipers when I change the fluid. Took it out on the...
It has both springs on the levers. Didn't know if you ever need to replace them. I'll look at the bushings as well
First time posting in here but I have been reading a lot in the forum. First let me say that I have always wanted an Argo. I finally was able to get a great deal on a used one. I duck hunt and was...