No ideas what to ask for this? After seeing my signature line its a 2015. Has a windshield, brush guard, blige pump, aux fans, cargo box liner, optima batteryt, outboard motor mount, trolling motor...
Type: Posts; User: jtb51b
No ideas what to ask for this? After seeing my signature line its a 2015. Has a windshield, brush guard, blige pump, aux fans, cargo box liner, optima batteryt, outboard motor mount, trolling motor...
If its the same as a Frontier 8x8, I have a 34/78 in mine. Its tight, but works like a champ.
Jason
I am thinking of selling my Argo 8x8. Its a 2014/2015 (cant recall, but can find out)camo efi frontier with a few add ons and 50 hours. This one has the EFI Kohler engine and 3.3 trans. The low hours...
Done and Done. Already installed the kit. Works like a champ now.
Thanks!
Jason
Lots of small engines use a fuel shutoff solenoid. They typically take 12 volts to run thru one wire and ground thru the body. Not sure why that would burn up with power, but it definately will stop...
Thank you, i didnt see this until after my last post. Thought I refreshed but no. I have no idea why they would have the system wired in all the way from end to end and it not be setup to work. There...
Traced the wiring using a Kohler manual. The MIL wiring IS intact and runs to the LCD. I have checked the system with a test light and it functions as it should, the MIL wire is the ground for the...
OK, am I reading correctly that you do NOT see the wire in the harness of this machine for a MIL? That would definately explain it! It makes no sense that argo would leave that very important...
Just tried 5 and 6 cycles with no luck. My display works, other than temperature. it has never worked and I was lead to believe they do not work on air cooled units. The oil pressure light...
Book says 3 times, starting off, ending ON.. Maybe it takes more? Still on bulb check but I will try more cycles. Mine is air cooled, they would be completely different engines, but please let me...
I spoke to a couple dealers that say yes. Both Adair and another in Nashville TN. I really dont recall ever seeing it on mine, but I never looked! I do know it should flash codes if you cycle the...
Well, I have replaced the ECU to get the machine running and now I am going to figure out why I have no check engine light. Thats a fairly necessary thing on an EFI engine.
Jason
MY argo dealer is in Adair Ia, I am in Birmingham AL. There is an argo dealer close, but they only sell the HDI unit (wont even order anything else) and I doubt they are a kohler repair center....
Just finished putting the Argo back together. The ECM WAS FAULTY. Not sure why, not sure if it will be warrantied or not but at least its back running. FYI, Still do NOT have a check engine light on...
OK, so I dont get to use my argo very often. It has 99 miles and about 35 hours on it. It will be 3 years old next month. The machine has killed the battery when it sits from day one, never a big...
Mine is more of a bark, but then again once it does it I stop and regroup.. These EFI engines have so much HP and TQ down low with no throttle lag. I believe I could make mine squeal longer and more...
I have never had mine in that situation, however what you describe I have had happen to me before. My parking brake was on. Seemed like without momentum I couldnt get out of my own tracks. Once I...
I have the 3.3 trans, and no tracks. I can squeal my belt also. It doesnt do it every time, but it does if I start in a turn, or have to hold the brakes on a hill and release them to move fwd.
...
I have had a 6x6 (albeit a max) and then my 8x8 frontier. I appreciate the additional power and easy handling of the argo over the max. The max was a good bit smaller and had ZERO room for cargo from...
I really like mine. I didnt realize I was supposed to leave the floor tray in with the cargo liner tho. It didnt seem to fit well. My floor tray it very warped tho, the sides are curved in at the...