Make sure you keep the front axel extension bolts tight, you should keep a wrench under your seat and make sure they are tight all the time, if not they will fail and they are not warrantied.
Type: Posts; User: jays64f85
Make sure you keep the front axel extension bolts tight, you should keep a wrench under your seat and make sure they are tight all the time, if not they will fail and they are not warrantied.
Check these bolts guys ( especially ) it you have the inserts, they should be checked almost every time you go out!
I have complete failure on both sides at 50 hours! ( front only ) after scheduled maintenance.
Has anybody had any problems with front inserts with their new argo? The inserts are kind of like a nut that fasten the wheel extension to the frame ( front three bolts ). Any advice on how this...
Thanks Vader8x8, It says in the manual to tighten these these bolts at 50 hours! I have 53 hours on my HDi and my left side inserts completely failed!
It sounds like you are missing the brass washer/spacer for your shut off solenoid, If the solenoid sits too deep (without the washer) - it will effect the flow of gas to your carb!
This is a weak design flaw! The plates that the inserts are attached to is very thin and can easily be pulled through even when they are tight. The plate is weak and the factory inserts are weak! Be...
Has anyone had any problems with the front axel extensions with their new 750 HDi 8X8? I recently purchased a new argo and I found that the front 3 bolts to the front axel extensions become loose...