You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact us. Looking forward to seeing you in the forums and talking about AATVs!
could someone with a factory argo winsheild get me the dims mainly the height. it may just fit under my roll/ brush bars. looking to make a custom canvas top but need to figure out windsheild. thanks
The windshield has a spacer that raises it up a few inches. Are you looking for this to be included? I will get both.
Lewis
23 and 1/2 inches dead bang in the middle of the machine. This measurement to includes a 2 and1/4 spacer. This spacer contacts the machine and the windshield mounts to it.
thanks lewis for the windsheild dims, i think a factory frame might work. could someone get me the dims for the tube frame. looking for height from floor pan lowest point in the rear area. also looking for the width of the frame across the top from side to side. looking through the gallery for factory set ups, looks like a factory frame set up or something homemade could be made to work under the roll bar/ brush guard set up on my bigfoot. thanks
okay put your tape measures away i found a solution. found generic boat bimini frames cut to your own needs. hardware and bends included just need to cut to length. thanks anyway.