Govenor

[mike bar]

Any one have a sure fire way to tell if a govenor is working properly. I can't tell if my motor is weak or if it's the govenor. I just ordered new springs and bushings as the bushings are gone and are not factory springs on there now. The throttle spring is hard on the wrist if driving any distance.It's huge compared to the one in manual.

001.JPG

[mike bar]

Any picture at all would do because i'm pretty sure this is not correct. Anyone?

[plott hound]

your throttle setup is totally different then my kt-17.will try to find a picture to see if they are supposed to be the same.

[plott hound]

Best Small Engines | Kohler Engine OEM Parts

hope this helps

[mike bar]

Thanks Plott, I have that printed off. Just don't know where to hook the springs up. There are three of them, and i only have the one which pulls the throttle back

[plott hound]

http://www.kohlerengines.com/onlinec.../tp_2204_b.pdf

section 6a shows my setup. section 6b must be yours.

[mike bar]

That's a pretty good pic. plott. You da man.