Originally Posted by
reichstall
Ok if any one had been following my prior post.You know that I was makeing new pins and keepers for track.If noone has ever taken there tracks apart.you want to pull a pin or two and look i was amazied at the wear on the pin but little or none on the plastic.I would have never thought they be that way.Also i am not sure if these were stock pins I am guessing yes but they are short to the point on some parts they had actually pulled out of the last hole they go in.The new pins I cut will extend about an 1/8 out side of last hole.Also if you can get them out and i fought it for a bit I put cutting wheel on 41/2 grinder and cut the pin in each slot it went through got to where i could do a section in under min .Got one side done today and other ready to go back tommorow oh yes lots of the pins were broken. just food for thought