ATTEX axle hub

  1. Welcome to 6x6 World.

    You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact us. Looking forward to seeing you in the forums and talking about AATVs!
+ Reply to Thread
Results 1 to 6 of 6

Thread: ATTEX axle hub

  1. #1
    Join Date
    Dec 2020
    Location
    Pa
    Posts
    21

    ATTEX axle hub

    Does anyone know how to separate an axle from the hub on an old Attex?

  2. #2
    Join Date
    May 2010
    Location
    Fairbanks AK
    Posts
    1,459
    Are you talking the slip over part with the bolt through it? If so I usually drill a large hole in the center so I can press it out wit piece of shaft. Usually have to put in a press and heat the sleeve while under pressure. I clean inside with a flap wheel on a drill extension.

  3. #3
    Join Date
    Jun 2011
    Location
    Western New York
    Posts
    457
    If it’s the “cone” style aluminum hub, there is a snap ring you access from the inner (body side) of the hub. It’s deep down there and you’ll need a good set of snap ring pliers.
    -Attex ST/300/D - "The Duck." Family owned since the early '70's
    -Attex ST/300/D- A-stock racer build! (not yet started)
    -Attex 440 Thunderchief Racer (not yet started)
    -Attex ST/400 (not yet started)
    -Hustler 980 BIGFOOT- A work in progress (SOLD)
    -1999 Max Buffalo Truck (SOLD)
    -1989 Max IV - A Max four my kids. (In progress)

  4. #4
    Join Date
    Jul 2011
    Location
    Clarkesville, GA
    Posts
    470
    Hey Duck. I have some from a st300d if that's what you're looking for. Aluminum cone 3 bolt I think. I can get pic tomorrow

  5. #5
    Join Date
    Jul 2011
    Location
    Clarkesville, GA
    Posts
    470
    This it?
    Attached Images
    Last edited by rickga; 01-06-2022 at 07:16 PM.

  6. #6
    Join Date
    Jul 2011
    Location
    Clarkesville, GA
    Posts
    470
    Quote Originally Posted by Duck89 View Post
    If it’s the “cone” style aluminum hub, there is a snap ring you access from the inner (body side) of the hub. It’s deep down there and you’ll need a good set of snap ring pliers.
    Sorry wrong thread. Disregard

+ Reply to Thread

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts