I'm down to needing just one of these if anyone has one please let me know
Type: Posts; User: turvuren
I'm down to needing just one of these if anyone has one please let me know
I'm looking for an ignition module/voltage regulator foxtruckcaps@epix.net
I need 4 of an inner bearing cup for an Attex Colt. It's a single half with 7/16 holes
My Attex which has been outside tarped for a while suddenly will only run with choke on. It has been rainy. I have looked at fuel tank in dark with a flashlight and can't see any water. Although it...
I don't think a 72" plow is a good idea, but I've moved a lot of snow with my Attex and 60" plow. As for wear and tear it's all in the technique you use and how carefully you shift it. My style in a...
It is important to have perfectly straight axles with your cage setup. You can check at the point when you are just snug on reassembly to see if your cages wobble when you turn the axle. I just did...
I'm wondering if anyone has put any effort into finding other places to race. I had an easy motorcross track in mind but they are shut down over a lawsuit.
Thanks I was able to buy a step key and with a little sanding got it together.
i've run into a problem with my china engine. The crankshaft with keyway installed measures .060 larger than the clutch. Any ideas?
Recreatives did a reprint of 50 more so they are available again
They are sold out of books at Recreatives. I hope enough people will request one to get a reprint done.
It's defnitely the feedback through the floor that is a problem for my knee. I haven't had problems bumping shins on dash. The foam that seems to work so nice for me has an egg crate pattern on it.
Anyone out there ever try softening up your floor with some foam. I came back from Ashtabula with a swollen knee and have stuck some 2" egg pattern foam on my floor. It really feels nice.
http://www.6x6world.com/gallery/data/505/thumbs/P4240136.JPG
I wanted to get this other picture in and haven't quite figured it ouy yet. I made the hood from scratch with plywood and fiberglass,but...
I finally have my project painted and presentable. I have two other pictures in gallery. I took an old Attex shell stretched 2 feet to 8x8 length, widened by 6" to get a 27" wheelchair inside and...
I have a fresh oh160 for my Tomahawk with ports cleaned up etc The biggest thing I have heard about is reinforcing the conecting rod and notching the cylinder to give more clearance. This is supposed...
I made a front axle of the c32 material and decided to go shorter- I have lots of rocks to avoid. I'll post again after I do opposite side and have chance to run it. I'm at 2" shorter and it looks...
What do you mean by "clocked" I realized just recently that my Attex has this problem on long rear chain. I could never maintain the tension I wanted. Last time I adjusted it I spun to average it...
I measured an Attex 252 crazy colt at 5&3/8
I think I can measure one tomorrow for you. Do you think the poly body machine is the same?