I have a jlo l297 which has the small crankshaft taper, and a Salsbury clutch with the larger 30mm taper. Is there a tapered bushing available which would allow me to use the 30mm tapered clutch?...
Type: Posts; User: Danth
I have a jlo l297 which has the small crankshaft taper, and a Salsbury clutch with the larger 30mm taper. Is there a tapered bushing available which would allow me to use the 30mm tapered clutch?...
The holes are in the lower front and would be covered by 8x8 inch patches.
Ok, no luck on finding a source for a body patch, but has anybody got a tub being used as a donor for body repair?
Hello everyone. I've got a Chief needing a patch to repair a
good size hole. Has anyone found a source for yellow sheet for a weld repair? Thanks, Dan
Thank you Chrisgt. That's what I will do. Nice job.
Does anyone reproduce the rear rubber motor mounts for an Attex 297?
I thought they might be discontinued. If you check, that would be great. Thanks
I recently purchased a Chief with four Carlisle ATV tires. They are 21x12-8. They have a V pattern tread across the entire width of the tire, just like the rimless balloon tires, but they mount on...
My JLO L297 has a 29mm keyed tapered crankshaft with an external threaded end. The clutch I need would have to have a keyed 29mm tapered bore and the draw bolt would have an internal thread to screw...
Purchased a 297 in pretty sad shape requiring a bit of body work. There are 4 holes which look suspiciously original on the bottom of the tub. Are these supposed to be there, and were they plugged?...
I'd appreciate your thoughts on the question of rebuilding an original Tillotson carb versus purchasing a new walbro.
Installing a L297 JLO into my Attex 297. Were vibration mounts used, or was the engine bolted right to the frame?
Yes, that's the one that prompted my question. I don't know if this would fit the earlier L297 with a 5 bolt head
I've been looking for a L297 piston and cylinder without luck. Was wondering if a 297/300 cylinder and piston would work, understanding I'd have to replace the 5 bolt head with a 6 bolt head.
Looking for a good piston and cylinder for a JLO L297. Still looking for an electric starter for same. Thanks, Dan
I'm trying to save a couple Firestone Balloon tires and found one with a leaky valve stem at the rim. Very slow leak. Since I'm going to Tireject all my tires, would I be best off relying on the...
In need of a good RH Firestone balloon tire for my Attex. Thanks, Dan
Did attex use a fused rectifier and if so, are they available?
In need of a good JLO single electric starter. Thanks, Dan
Another question: The wiring diagram shows a fused rectifier. Are these available anywhere? Thanks, Dan