Thanks guys. Ill try what you have suggested. Really dont want to pull another t20. That process really stinks without an overhead winch or come along. Those v twins are heavy when you lift em out by...
Type: Posts; User: patb069
Thanks guys. Ill try what you have suggested. Really dont want to pull another t20. That process really stinks without an overhead winch or come along. Those v twins are heavy when you lift em out by...
Thanks all. I checked the parking brake, not it, but thank you for the suggestion Bridget. No radiator on the Briggs 18 hp, still no trans fluid in the tub. Could it be getting burned up in the T20...
Hi all. So i was out enjoying the snow tonight and after about a 15 minute ride at continuous full throttle driving i went back home. When i pulled the machine into the garage I noticed a sweet...
Thanks for all of the input guys. The problem is the governor. When I manipulated it by hand while driving the rpms came up and the machine took off. George is going to come by and help me set it. I...
Thanks fuys. I will be ordering one today. I just looked. I have the red governor spring. Looks like I will need the Rev kit as well.
Hi guys. Thanks for the input. Belt seems to be set perfect. Clutches are working properly. I think Mark may be right. The engine is a brand new 23hp vanguard. The engine does not seem to be turning...
It's been 10 months. I took my machine out after rebuilding the entire Maxiv. Literally every nut and bolt has been replaced. I am really ready to flip out. Took it out for a maiden ride tonight and...
Thanks guys. Drew hit it. I was trying to come from the back of the machine.I found the second mounting location on the throttle bellcrank. Going to have to install a new choke cable though. Short by...
Hi all. Frame is done, motor is mounted. How do i mate the vanguard motor to the tecumseh wiring harness, or do i just run all new wires? Thinking about rewiring because the under dash wiring looks...
Congrats on the new whip. Looks great.
Thanks for all the help guys. With a little assistance of a 5 ton 3 jaw puller the clutch came apart fairly seemlessly. I used white out to mark both sides of the spring locations. I am going to...
Thanks John. So if I use my stock belt on the larger clutch would I get the same performance as the factory size? Reason I am asking is I am having issues with my factory clutch and had this one as a...
Hi guys. I have a larger diameter secondary clutch than the factory one that came with the Max Iv. Is there any benefit to using this over the factory one? I would assume more top end speed, bit not...
OK. Now I am frustrated. I made a spring compressor and with my impact gun, got the helix to go down another quarter of an inch. It is now stuck there. I have whacked it, heated it and compressed it...
Thanls guys. Nubs, you are right, i meant the driven clutch. I went to home depot and bought a threaddd rod. I am going to bend some iron to fit around the clutch head. I feel like i have a timebomb...
Hi guys. I am in the process of upgrading the primary clutch spring. I have removed the snap ring from the back of the primary clutch. The halves won't come apart. What am I missing here?:hmmmm2:
They take a 1/2 inch bolt.
Whats your email? I have actual to size diagrams with dimensions of each individual piece of the kit .
Has anyone seen this before? I torqued the plungers down to 20 inch pounds using the plunger tools. They do not sit the same between the left and right sides. If looking at the plungers, the top left...
128561285512854