Question on greasing outer bearings.
Ive read the outer bearings are to be greased every 10 hours. Some people suggest grease every time you do a heavy dose of water work. That could be daily.
...
Type: Posts; User: Peterac
Question on greasing outer bearings.
Ive read the outer bearings are to be greased every 10 hours. Some people suggest grease every time you do a heavy dose of water work. That could be daily.
...
Bit bizarre as it is now working fine. Concerned issue will resurface. Guess I?m back to enjoying the ride.
I’m not with the Argo at present but yes when in gear it drives normally. I will try giving throttle slight rev later today.
2012 Frontier carb model. Only 100 hours.
Trans issue.
Ive just noticed an issue when changing gears. I stop, shift into neutral to idle or reverse. When I try to put back into high or low...
2012 Frontier carb model. Only 100 hours.
Trans issue.
I?ve just noticed an issue when changing gears. I stop, shift into neutral to idle or reverse. When I try to put back into high or low...
Thanks, apart from the screw all other has been adjusted by manual direction. I’ll move screw forward to touch.
Stop screw backed to point where throttle shaft doesn’t touch. I wondered if governor weights are not fully returning? Thanks for reply.
23hp Vanguard. Sometimes my idle is 1100rpm, sometimes 900rpm, sometimes 1200rpm. Whatever it drops to it’s a smooth consistent idle until I blip the throttle. All throttle linkages/springs are...
I tried to attach photos but struggle with the tech on the phone.
Anyway, I seem to have gotten idle down to 700 - 1100 rpm. More consistently around 900. This I’m happy with enough. I have to wait...
I still haven’t got idle down below 1100 and it hovers mostly around 1200now. Apart from that it’s is running great. Top end no load rpm is 4000. Tabs were bent as you suggested Laird.
I reset...
Good one! I used a big bloody screwdriver but like yours better. I bent the tab you said to get the no load top end rpm to 4000. Still won’t go faster when in gear so I will go back to the governor...
https://buggiesgonewild.com/
Admin delete this link if not appropriate.
The link is to a forum that mods their motors (ie remove governor and add an electronic tachometer) for all sorts of reasons,...
I put in gaskets, all good but…..I tried some fiddling. Previously it would top out at 16mph. This is slow so I straightened out my governor/throttle linkage. It went to 23mph but idle went to...
Yes I expect vacuum leak but what symptom. Put homemade gasket in and idle has dropped a little but so has top end speed. Will now fiddle with adjustment tab.
Thanks John, I guess fuel vaporising causing air lock? Same, I’m on a farm with stock fan on Argo so all should be good.
I had a stripped bolt on the engine and had to remove the carby to repair. Then I noticed…..no gaskets on either side of carby. Will ring mechanic who cleaned and overhauled my engine.
Would lack...
Noel my conversation with B&S tech was they are designed to idle at 1750, end of conversation. When the motor overheats what happens?
Laird, thanks I understand the tech thing. Look forward to it if it happens.
You’ve given me something to keep an eye on, thankyou.
What is your idle speed when you shift? The lower the better.