I've researched this thread but didn't find any answers. My 2006 Bigfoot is pulling to the right so bad I have to make abrupt corrections every 5 feet. After the brakes get warm I get a severe squealing on the right side. I just replaced the master cylinders, rods, and hold-brake cable. I put Dot 5 in both cylinders and bled em. I know it's in my brakes. I can't have them deer hearing that squealing this weekend.
Did you check tire size/air pressure on both sides. As well check your idler chain tension. When you changed you fluid did you make sure there was nothing left in the lines....may have been some moisture there??????
Even if you’re on the right track, you’ll get run over if you just sit there.
—Will Rogers
Tires and chain tension are good, brake fan is working. I have a pasture behind my house and can only make it twice around before the right brake gets hot and starts squealing. Once it gets hot it pulls to the right. There is dot 5 residue on the rotor/caliper, but can't see that causing the brake grabbing. Any ideas on what would cause the right brake to grab? Does anyone know of a dealer close to Albany Georgia?
Check that the 2 tabs on the tbar where the plungers go through are not bent forward, the stops should barely contact the tabs. If the are hitting adjust them, if tabs are bent straighten them first, the check the rod adjustment (you should be able to spin them with your fingers fairly easily).
Next time you take it for a spin and the brake tightens try loosening off the cover to the caliper to see it that releases the brake.
Even if you’re on the right track, you’ll get run over if you just sit there.
—Will Rogers
What about a sticking piston in the caliper?
Posting Permissions
Reply With Quote