I’m wanting to replace the rods that hook to the diamond shifters on my max 4 with solid adjustable rods would anyone know the measurements to make some
Type: Posts; User: Greasemonkey990
I’m wanting to replace the rods that hook to the diamond shifters on my max 4 with solid adjustable rods would anyone know the measurements to make some
My Subaru is the first year with fuel injection. The coil isn't firing kind the injector isn't working. So far I've checked all the fuses and swapped the distributor. I'm kind of leaning to a bad...
I know that a lot of folks on this site have been working on machines for along time. Does anyone have any experience working on old Subaru cars. I have a 87 gl wagon not running and I’m trying to...
I recently got my max 4 back up and running after it has been sitting for a year. Got it running great. Had to replace some axle bearings,belt, and clean the carb. It runs better than it ever has. I...
Do you have sprockets left
My rear chain that powers the left side of my max 4 decided to come off and tear up my sprocket I need a used rear sprocket if anyone has one laying around
I finally got it the rod on the right side shifter was hooked u backwards, and it was bent. Reverse works but can't hardly make it go in reverse.is there an adjustment that I
Will allow the pin...
I understand that these machines can be hard to get in reverse. When I first got it I could rock it around and make it go in reverse. I haven't been able to get reverse in months. I can rock it and...
They have Argo stamped on them but I figured they was with the max because the was sold side by side. The only problem with the tracks I saw was where the pin slides through to hold each track to one...
This past weekend I went to a local auction and purchased a max 2 serial # 7132 . It is missing the motor, seat, gas tank and has no wiring . But it has the transmission I need to fix my Max 2. It's...
Finally found me a jet from a 18 briggs. I put it in my 16 and it runs great! Thanks for all the help.
Sounds easy enough. I have had my carb apart before.i want to make sure I drill the right holes.is the jet the small tube with all the holes in it. I had to clean those holes to get it running when I...
What do I need to do put the restrictors back in or can I adjust the carb somehow.
Thanks
I was reading that the only difference between a 16 hp and a 18 hp is the restrictors in the exhaust valves.Supposedly you take them out of a 16hp it turns into a 18 hp. I tried this and it seems to...
I live in North Florida and I have been wondering how to register my Max 4 as a boat. Nobody around here can tell me.
I have three old snowmobiles two are bolens from late sixties early seventies. One has a 295 two cyl. The other has a three cyl motor. Both are two cycle. I also own a max 4 with a 16 horse Briggs....
I've had a max 2 for a few years and I recently purchased a max 4 that has been sitting for ten years. I'm might need some advice from time to time. I live in North Florida and in my town most people...