I pulled my tracks off the other day, and found that I had 6 loose outer axle bearings. A couple of them were not too bad, and all of them would have been fine for a while. However, I had the parts and (I thought) a bit of time, before I was supposed to go for a ride with friends, so I replaced them. I ended up in a bit of a hurry. You won't find any white shop coats and clean hands in this vid, but if you want to see how to change a brng and seals on an Argo, you can check it out.
Yes, I know my shop AND my Argo are a mess right now
I found it suprisingly difficult to make this vid, but I think it turned out OK. I think I covered most of it, but did miss tightening the inner brng setscrews.
RD
The new tires are working out well and have got...
The new tires are working out well and have got the little Max's engine dialed in perfect. This is a great machine.
Nortonscustoms 05-04-2024, 12:24 PMCouple photos of the Max doing Max stuff.
...