You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact us. Looking forward to seeing you in the forums and talking about AATVs!
I put on 2 new tires today and started servicing it. I greased every zerk I could find but I could only find them on the outside bearings. No zerks inside the tub. I had to pull the carb off and...
So I received the manual with the Argo. It?s a 1987 model with the 18hp Kohler engine. It only has 192.5 hours on it! A mouse has gotten in it and chewed a few wires though, so I?m going to have to...
Well I guess you can say I?m afflicted with the sickness now? I bought another project lol. My wife sent me a facebook marketplace post for a Argo. They were asking $1200 but I offered $1000 and they...
Quick update on machine. Still runs like a champ ,right around 160 hrs on it now. Need to do that axle service where you change gear oil for bearings. Notice I’ve got an axle seal starting to leak...
Great seeing everyone. Had a great weekend, wish wind would have slowed down, didn't ride as much as usual. Doesn't help when stuff breaks lol. Everyone take care until next time
I pulled my tracks off the other day, and found that I had 6 loose outer axle bearings. A couple of them were not too bad, and all of them would have been fine for a while. However, I had the parts and (I thought) a bit of time, before I was supposed to go for a ride with friends, so I replaced them. I ended up in a bit of a hurry. You won't find any white shop coats and clean hands in this vid, but if you want to see how to change a brng and seals on an Argo, you can check it out.
Yes, I know my shop AND my Argo are a mess right now
I found it suprisingly difficult to make this vid, but I think it turned out OK. I think I covered most of it, but did miss tightening the inner brng setscrews.
I put on 2 new tires today and started servicing...
I put on 2 new tires today and started servicing it. I greased every zerk I could find but I could only find them on the outside bearings. No zerks inside the tub. I had to pull the carb off and...
Rowdy 04-23-2024, 10:20 PM