You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact us. Looking forward to seeing you in the forums and talking about AATVs!
I know we have discussed this before. Are you still using the original braided ground strap? I’ve had several fail in the crimped ends. Have you used a jumper battery when it acts up? The added...
I should have mentioned I have the 27 hp Kawasaki. The solenoid is on the starter itself. The solenoid clicks but doesn’t engage to the flywheel. I will triple check the wiring. Such an intermittent...
Since you provided a list of items you have done, I believe you have either a bad starter solenoid or there is still an issue with the wiring such as a loose connection or an internal break in a...
What engine do you have? When you say it clicks but wont engage, where is the click coming from? Is the solenoid clicking and the starter motor not spinning? Or is the starter not engaging the ring...
Try checking the amp draw the next time it happens. If it is real high at the starter try turning the engine over by hand, then try the key again. If you have little to no amp draw you know the...
Well, I finally got this little project started. I think everything is going to work out good, but there is still some testing to do. I ran into a couple little issues, but nothing that can't be dealt with.
Sorry about the length of the vids, it was hard to keep the time down on a project like this. I have only uploaded the first part so far, but PT-2 will be edited into this post tomorrow if possible.
I have to say here that I'm NOT SURE if this will work with ALL Conquests. I have noted that some older Conquests have different Bearing Extensions. Mine has the ones that require both the inner and outer bearing retainer when mounting Bearings in the bearing extensions. Some Conquests bearing extensions have the inner bearing retainer built into the bearing extensions. It may work, it may not. To find out what you have, look at your machines front/rear bearing extension assemblies. If you only see one gasket behind your outer bearing retainers, you have built in INNER bearing retainers. If you see 2 gaskets with a plate between, you have the same assemblies as mine.
I know we have discussed this before. Are you...
I know we have discussed this before. Are you still using the original braided ground strap? I’ve had several fail in the crimped ends. Have you used a jumper battery when it acts up? The added...
msafi65 03-28-2024, 07:15 PM