Did you get to test your machine yet Coast2Coast? I had the same problem with my 98 conquest. I never actually noticed it till I got it out ice fishing on the lakes and it was exactly as you...
Type: Posts; User: Trapper Dano
Did you get to test your machine yet Coast2Coast? I had the same problem with my 98 conquest. I never actually noticed it till I got it out ice fishing on the lakes and it was exactly as you...
Pads are not tight against rotor, still goes left. Odd though I set the park brake and then got on the gas and went straight right round in a circle, like the left break wasn't grabbing at all? Would...
Thanks Curtis i am going to try that tomorrow morning!
Finally got a chance to spend a couple minutes on the machine. Adjusted the idler chain left side was looser then right, snugged it up to match right side at 1/8 of an inch. No difference still,...
Yeah was thinking that might be the best way, get the whole machine off the ground and compare side to side.
Thanks Curtis, frustrates the H#ll out of me. Bought it to keep my son safe trapping in the woods and I just cant seem to get it right for him. Have kinda brushed over the brakes, will have to check...
tire pressure is all equal at 4 pounds. Had 2 bead leaks fixed, wasn't the problem. How can I check to see if brake is dragging? Set the machine up on axle stands and try to spin tires or is there...
My 1997 Bigfoot chronically pulls to the left, so much so that I am constantly bumping the right brake to keep it chicken tracking down the trail. I used the brake so much the Argo never gets up to...
Thanks I think I might just invest in the tool and the compound.
Both heads are identical, the intake and exhaust match up on both sides. And the compression was done plugs out.
It...
Just got home and pulled the other valve cover to compare valve seals, both heads look identical. I guess I might as well pull the head off that side to just to make sure it and the piston and are...
Yeah Jim i have spark in both, even put brand new plugs in it.
I thought the same thing that it was too high and had no clue how it could get that high. I retested both cylinders 5 times always got the same readings 90 in front and just shy of 170 in the rear...
161781617916180161781617916180
Thanks Hipowerone
One side was 90, and the side I pulled the head on was 170. When I did the pull the pull the plug wires test, unplugging the 90 cylinder caused it to run rougher, whereas unplugging the 170 cylinder...
Is there a way to post photos here? I pulled the head tonight that had 170 compression. I think it might be a valve guide? Would like to.post a photo so someone could maybe confirm. Never opened a...
Got out to the garage tonight and pulled the head that had the head that read 170 compression. Took so.easy photos of the head and the valve springs and guide. I think it might be a valvr guide? Is...
Snuck out of work at lunch. Checked the tappets adjusted one a tiny amoumt all are .004 did a new compression test still 90 in the front cylinder and 170 in the back. Could it be my compression...
Checked the push rods they are all straight. picked up a feeler gauge but wont get a chance to work on the machine again until Thursday night likely, will check all the valves and set them all the...
Just did a compression test on the motor a hair under 90 on the front cylinder and about 165 on back cylinder? the smoke is white