Sold off all my argo's and parts. Still have an old Max 11 and a Passe Partout. Plans are to totally redo the Passe Partout and if at all possible use the T20 from the max in it. If the T20 will not...
Type: Posts; User: greggv2007
Sold off all my argo's and parts. Still have an old Max 11 and a Passe Partout. Plans are to totally redo the Passe Partout and if at all possible use the T20 from the max in it. If the T20 will not...
They are not amphibious. They are not real fast. They will go through swamp and muskeg very well, and they hardly leave a track.The one I have , I have put a 18 hp briggs into it ,and it goes great....
Thanks A.D.
I have an opportunity to buy a buffalo truck, serial # 9438. Could anyone tell me the approximate year of this unit. I am assuming by the numbers, probably in the late 80's or early 90's any help...
I had this happen once with a briggs v-twin. The wire connected to the two coils has a diode in it, and the diode failed. I replaced the wire, and no problems since.
There is a place in Calgary Alberta, Canada. His website is Raidtrac He has got a lot of parts for various tracked machines.
Is there different tension of springs for the levers on a max11? When I go into reverse, I have to really brace myself or almost slide off the seat. I would like to have some tension for forward but...
Install a oil pressure switch at your oil filter, and wire it through that. The hour meter only works with the motor running.
For anyone who was looking for information about buying from USA, the following is an e-mail that I received from Lima, Christina (CLima@riv.ca): Quote: A 6 wheeled ATV...
Merry Christmas and Best Wishes in the New Year to all
Well said JP.
To my knowledge there is no adjustment for the front chains, just replace them. The sprockets should be ok as long as they have a small flat on the end and don't come right to a point.
Plott Hound A measurement of 10 5/8 inches would give you 17 links in # 50 chain. As 50 chain has a span of 5/8 of an inch from pin to pin. As an example [ 1 link = 5/8" , 2=1 1/4", 4= 2 1/2", 8=...
Looking to see if anyone has had this problem? I installed an 18 hp Briggs in a Max 11,[ it was a used engine that I picked up], I started the engine and run it for about 2 minutes, just to check...
Congat's Beeman. Now you have an excuse to get more machines.
Uploaded some pic's of Li'l Six. They seemed to go in the reverse order, so to make sense of the description veiw them from right to left.
...
If you are in need of a couple of axles I may have some. I will have a look tommorrow.
Running Toro Trucks, [Made in Sweden] MacLean bolters, and Cat scoops [formerly Elphinstone from Australia]. Atlas Copco drills. The trucks and scoops have 5 1/2 foot high tires, so it may have been...
Was in Calgary Ab. this Sept. and went and talked to Mark at Raidtrack. From what I seen there he seems to build the machines as needed. He did have a couple on hand, but he told me that he had some...
Arrived in Flin Flon Mb. Took a trip to the mine, 1262 meters underground. Not much light when you are that far down. Seen 40 ton rock trucks, 10 yard scoop trams, jumbo drills and roof bolters....