Forum: Attex ATVs

i just started on the motor and trany for the racer and noticed that almost all of the rubber mounts between the motor mount and trany mount are...

while fixing some cracks in my abs body, i noticed that the acetone brought back the shine to any area where i brushed it on. i've been sanding and...

I cracked my cracks again. The ones between the front and middle tires from slamming against fallen logs when climbing them. I just cant control...

I've got the locking collar off the outside bearing and the axle is out of the machine but the bearing doesn't seem to want to move. Should it just...

Some of the bolts and frame holes that hold the outer bearing flange to the frame are stripped out. I used some nuts on the inside to keep them...

how do i get the ecentric collar to tighten to the axle, i turned it as much as i could, but then the bearing just starts to turn. do i just go as...

Since I'm putting 240lbs. of batteries where the engine was plus a 60lb. electric motor on top of the T-20 I was wondering what the heaviest engine...

I am new here and read about the McKay racer. Can I get a little back ground on this machine? It would be cool if it was one of Ronnie or Roger...

I want to install some skid plates on the bottom. I would rather not use nut an bolts. anyone have any idaes how to seal the skid plates in place on...

I am having a absolute blast with my superchief! :D The wife loves it, the kids love it, everyone that sees it is amused. I had it in the water over...

OK I'm running out of ideas here. I had the right front chain off the Attex to replace the bent axle with a new one from Whipper and now I can't get...

I am thinking of buying an electric trolling motor for my 8x8 Avenger & was wondering if any of you guys are running these motors. The motor that I...

Ive been on a mission the last few nights to seal up the leaks in my superchief. Ive taken all the outer hubs/bearings apart and resealed them. All...

My motor seems to move alot on its mounts when the clutch engages.....I was looking at the mounts today and something just doesnt look correct. Is...

Hello everyone, I need some advice on rims for my Attex project. I need to purchase (6) new rims to go along with my new tires (Rawhide III...

I just bought a 400 chief, but the engine it came with (400 ccw) just wont idle while it is warm or after a while of running it, also the left...

Hello everyone, It looks like my 72 400 chief project is going to get mobile this weekend. The drive belt that is on the machine is in so-so...

Presenting….Attex Assault 2!