Forum: Hustler ATVs

When i pulled the t20 out because of the loose mounting bolts i didnt stop there. I decided to tear it all apart to repaint the frame check all the...

I just bought what I think is a Hustler 900 (poly body, Kohler 440, single shift lever, 21" tires), so this is the first of what will probably be...

Should I push my axle in as far as I can or is there some sort of "stop" built into the axle to prevent it from going in to far? Hope that make...

Another upgrade for the 950 was to convert an old bicycle brake lever for use as my throttle lever. This only took about an hour to install. But...

I've had a couple Max IV's in the past, but I was wondering if a Hustler outperforms a Max IV in mud, water, land, handling, etc. I know the Hustler...

Guys, what should I be looking for? With my Hustler off the ground I rotate my wheels and my front and and rear drive chains go from Very Tight to...

Dose anyone know for sure what the max tire size is that I could use on a 900? I currently have 21x11x8 Goodyears. I'd like to keep the 8" rims...

anyone know the length of the rear most chain? I have 3 sections of new chain and dont know how much I really need,

I've got an early seventies Hustler with a 440cc Kohler fan cooled two cylinder two cycle engine..I know it's not stock. The origional owner said it...

has anyone ever used an extra tub, cut down, for a skid pan on a Hustler. My thought on the subject is to trim it down to just below the holes for...

I'm new here but, I had a question on my hustler, the round white plastic chain tensioners are they suppose to have a regular standard bolt through...

I see a lot of discussion about the difference in the depth of the 980 tubs and the older styles. Can someone please put some actual dimentions to...

I bought a junker for the engine cover and discovered that the tranny may be O K, it appears to be a 950 with the 2 cycle engine. I have the belt...

Just a thought. What would be wrong with having a small oring groove cut in the axle where the outter bearing rides? Then you could have a small...

I guys I just found your great site!I just picked up a sidewinder 73?Its a project with no motor.Question I have is what motor to put in it I posted...

Anybody have the length and width on a 980? Might be picking one up and would like to load it in the bed of a pickup truck.

ok, so i got some pics of my hustler gunna start work on it soon and ill post the pics ...... few questions .. whats the difference in hustler 900...

I have a hustler(950???) with a chinese 16 hp and comet duster clutch.I am guessing a original driven pulley.The belt on it is only 15/16 wide.I...