Forum: Transmissions

Hello, I live in Brazil. Here dont exist this curious and fascinating machine, however I am a manufacturer of motorcycles and other machines. I have...

I have an argo transmission that I picked up cheap for my argo. After buying two new discs, I tried to get the old ones off and the shaft fell out....

Hi All. I Will Be In The Myrtle Beach Area Next Week, Anyone Know Of Dealer In Town That I Could Order A Commet Duster C94 From For My Honda 24 Hp...

As many here know, Richard's Relics sells a High Speed Clutch for $300 that some boardmembers swear by as a simple way to give the Max IV more get up...

Anyone had any luck with the Comet 94 C clutch.. on a MAX II I will have to use one if i keep my 24 hp Honda drop in motor plans, but scared the...

A small chip of rubber flew of my belt the other day so I replaced it with a new one. The new one is 2mm wider than the old one, but when i open up...

wondering what the difference between two stroke and four stroke tension used on the secondary clutch? I would think that the ones used in two stroke...

I have a comet TAV 30 clutch. Can I use it on an old Attex st300d?

I was wondering if anyone knows the proper way to shim a driven clutch on the t-20 in order to spread the sheaves to except a slightly larger belt. ...

I'm having an issue with my CVT system and I'd thought I'd throw it out there to find a solution. Here is a history of what's going on: I...

I want to shorten several double-50 chains in my Argo. Does anyone have a favorite way of removing links? I have done some searches for chain...

Can anyone please tell me what fluid I should be running in an older Max IV trans?

I'm looking into using a Generac engine in a custom Attex I want to build from the ground up. The Generac is very similar to a Kohler, Briggs, etc....

I have a max II with a salsbury clutch that is junk . what is the best think to put on there will a comet 94 c work all right with the stock driven...

Hi everyone,Well It took fifty years but I finally Got one. Its a 1969 scrambler with a Baker Hill 5000 trans.Trying to find steering pucks or can I...

I have an early nineties Max IV project that I am trying to finish. I need to get both clutches. I have a Kohler 24 hp engine with a 1" shaft and the...

Hey, I was looking for a fan belt for the Kohler 440 and I know what snowmobile it was used in back in the day. I found that the Gates catalog...

Hey Folks, in the 6x6 world I have 3 Salisbury clutches, I need to I.D.! They have no model numbers that I can find. The actual problem I am havin'...

Hi guys, On my skipper rebuild, I have found the driven clutch to be 1 3/16 inch shaft size. Comet doesn't make a driven clutch w/ this size that...

Hi all, so, I'm a little (well, a lot) confused about "split shifting" if I may, I'll pose some questions, maybe, someone would be kind enough...