Forum: Transmissions

Hi. After a test ride of our Max IV the machine wouldn't turn left in reverse. Then it wouldn't turn going forward. Then it wouldn't go at all. Then...

Hi everyone. I got my max together (thanks to so many on this board) and it became clear I did not adjust the T20 correctly. So today I made a set...

Rather unusual question, but what steel is the T20 input shaft made of? I intend to buy another used shaft, cut the clutch-end off and have it...

I was showing a friend how to pull clutch's apart. He has reciently purchased a Conquest (Orange one in the clips), and wanted to see how to do it. I...

just found this press release on another site and figured i'd copy/ paste it here. i'm not sure if it has already been posted, but i don't remember...

got a new attex today,its a 400st,i think,i post the picture in the gallery,its in great shape,my question is what fluid goes in the t-20 tranny,what...

Here's a short video from last weekend at Ashtabula where an Argo Bigfoot had a hard time with wheel spin in the mud hole. But 2 MaxII's both with...

I found a really good deal on a used Kohler Command 25:rock:, and will be purchasing it in the near future for my Hustler. Since I'm getting a new...

Hi, just recently experiencing some nasty steering problems with my centaur. It's operating in a very cold environment (Norway), I started to get...

This is on a machine I just purchased, with 75 hrs. The trans is factory original and the previous owner said he had no issue with it before he...

i am about to change my transmission fluid in my 08 frontier 6x6 and i have been to 2 different parts stores looking for this and i can't find it....

I am an excited new owner of an ATTEX 6x6. Always wanted one, but never could find a good enough deal to allow it. The other day cruising through...

I have a chart (which I have been trying to upload, but to no avail) which outlines various spring and roller combinations for the 780 drive clutch. ...

Has anyone had trouble with their u channels bolts being too short after installing these bands? Aside from not being comfortable with one or two...

OK...the crossover I traced down was a epic failure....so I'm going to measure the belt I need out myself...these are my questions...with the engine...

I don't know jack about this. I am about to go on a research binge on this site for information. I figured I'd post my pics and questions and see if...

I recently traded for the elusive 8X8 Swamp Fox in Alaska and am trying to get it going. It appears to have the T20 tranny with an additional 2 speed...

What are they worth? Where do I find one? What HP can they handle?:dontknow: