Forum: Transmissions

I have an early big max that had the 2 cylinder 2-stroke engine. It ran ok strong with a scary top speed but was very finnicky with the carb and no...

i'm looking at a max iv and can you put new plunger o rings in a t20 without tearing down or is a tearing down the only way?

Hi I'm looking at a max ii the man that has it says it leaks out of the right side clevis hole and it does not steer right that well because of...

Hiya Mike. How would I know if my T-20 is in specs? What would I check? I don't have an owner's manual for it. After I check the specs for it, I'll...

Was wondering if anyone has replaced the plunger sleeves on a T-20? Mine were leaking pretty bad, and after disassembly have found deep grooves in...

Today I set out on diagnosing and repairing the T20 Transmission in my Hustler 6x6. The symptoms I had noticed were a grinding noise when turning...

I am new to all of this and building a terra tiger I have a newer 16hp b&s v-twin I want to stick in there, what is a good primary clutch to use?...

I broke the right side output shaft sprocket on my Max do they make some kind of upgraded aftermarket sprockets do you guys suggest regearing while I...

I'm really new to this 6x6. Just changed the T-20 fluid, 14 oz's came out. Put in 28 oz w/ 4oz. runs well when in gear. any ideas where to statr...

Any body have any maintenance info like oil type, level checking etc, Picked up a Jacobsen uv4- like pug and getting it up and running Thanks Gordy

I have been searching around online, it seems like alot of the aatv's and even snowmobiles share a similar clutch/torque converter setup. Mine is not...

I picked up a 1988 8x8 model KB with reverse not working Having taken the tranny out and split it, it looks like the circlip holding the dowel for...

We have two vanguard II's, a 96 and a 98. Just returned from 2 weeks in the boreal; our first foray with the argo's. Learned a lot about driving...

Who or were is a good place to get a cvt clutch with a 1in bore

I have noticed when my machine (new Max IV) is pulling hard, the belt tends to slip. The engine doesn't seem to be bogging down more than I would...

I have a 2004 and 2008 Argo avenger and both have the shifter shaft freely rotate so therefore the knob is all over the place pointing in differient...

I pulled my tranny out in order to rebuild it because it keeps jumping out of gear. The laptop I had my manuals on has bit the big one and I cannot...