Forum: Transmissions

how do u adjust the bands in the trans. mostly the forward drive bands they are weak

if you put the t-20 in forward on one side and in reverse on the other will it hurt the trans?

from pics i have seen my trans looks bigger than the t-20

Im just getting the new engine (14hp Subaru) and clutch (40 series comet) in my 1968 terra tiger. I was wondering how do you find the right size...

So I recently replaced the very worn out belt on my Coot, the original was starting to delaminate and was WAY too long (could easily pinch the middle...

Opened up my Torque Transmitters on the new coot. Front box is 100% sealed and full. Rear box leaked any fluid above the drive shaft bearings....

With the Coot running so great I drove it a ton over the weekend. 1.5 hours on Sat and 2 on Sunday. I have noticed the torque transfer boxes ...

I have been taking apart an older t-20 out of an Attex, the ones with the brake rotors on em, and I have noticed some variation from your t-20...

Hi Just posted the parts manual section of the borg warner/6plunger type transmission, enjoy! (not that you'll probably ever need...

is there a reason why attex quit using the baker hill trans and used the t-20? when max wouldn't sell them the t-20 anymore, why didn't they use the...

I'm looking into using a Generac engine in a custom Attex I want to build from the ground up. The Generac is very similar to a Kohler, Briggs, etc....

so there are a couple different ways i can steer an amphib...there's the attex 6000 which is simply gearing down the engine and enabling steering...

I pulled my non leaking 7000 out to service lube and check the pucks. Drained and refilled the trans. put back and now it drains out clutch side like...

Well I am due for some pucks Smiley/ST400R, are these OK ? Welcome to Richard's Relics Parts for ATV's They sure don't look like mine as mine...

Hello all, I havent posted in a while, Ive been working on diffrent project but thought that i would ride the Max lV around the yard the other day...

I didn't have anything to do today so i thought I'd pull my T20 apart to see how it works and what the guts looked like. I've read that the bands...

I recieved my new bands and bearing and seal kit for my T20 and got it all back togeather over the weekend and while trying to bench adjust the bands...

I have had the max out twice now and have had the snap ring on the output shaft on right side of T20 come off, now when I sent for the rebuild kit it...

In the how to section under transmissions there is an article named T-20 Skid Steer rebuild posted by jpswift1 and I cant seem to find the part two...

I'm in the process of trying to get everything adjusted after a frame out restoration on my Max IV and in the long journey of this I thought I might...