Forum: Transmissions

I'll be running large tracks for snow (18 to 20 inches wide). I heard people complaining about the t20 starting to slip when overheated. So... Is...

I just bought a hustler this last saturday. I have problems turnig to the left while moving forward. If I come to a complete stop I can turn to the...

a friend put the 2 shifters in his max 2 for it to CR . it will not . need some ideas thanks. robbie

Were can one of these be purchased ? scot

I have been in the design stages for a transmission that would be a bolt in, economical replacement for the T-20 trans. Most of us love the t-20, but...

Can someone tell me how to make the band adjustment spacer tool? If I can figure out the thickness I can do the rest. Is it 5/16" ?

my max II motor clutch will not squeeze the belt to the top. should it squeeze all the way to the top? about how far down inside the tranny clutch...

I'm only home for one day this week and working on the super chief I got last week not running yet as I did not have time to rebuild the carb. I...

G'day Whats the simplest way to remove the bolt holding the driver clutch onto the drive shaft of a 17hp Kohler. Clutch is PowerBloc. Is it left...

Hi there, I'm new to argos but not new to spinnin wrenches by any stretch. I have picked up what I believe is an 81-86 8x8 argo with the kohler 17hp...

Where can i buy two shifting rod linkgages that connect on top of the t-20. they have the red springs on them. Thanks.

Anyone have a recommendation for replacement brake pucks on a baker hill 5000 or the best place and type friction material to use for replacement and...

greetings, I ve been in the 80 hustler 900/950 restoration mode for a few years and the tranny still isnt quite right. its been rebuilt and run...

I'm rebuilding my T20 transmission, not because of leaks, but because one of the diamond shifters got stuck in forward position. When I opened it, I...

I'm reassembling a T-20 with many new parts. The issue I'm having is with the left side main shaft with the sprocket on it. The new bearing is all...

I'll admit straight up that I haven't looked at the IPB but probably will just to satisfy my desire to understand the operating principles of both...

I have a attex 400 chief jlo,i would like to know how much slack it should have? It seem like a lot i can all most squeez the top and bottom and make...

bad day in the life of a t 20 .a day at DON'S.working on our t 20 from the max IV thanks don !!!!! now to buy parts. fun fun fun .