Forum: Transmissions

Are there sprockets available for the t-20 trans with different number of teeth on them? If so, where can you get them? I am increasing the tire size...

I'm wondering what would cause a pulse on one of the sticks with the (engine running) in neutral. This is on my Max IV and I'm planning on pulling...

need a little advice before i button my old argo back up.while testing my clutches i observed that the driver clutch is offset from the driven clutch...

i have a hustler 950 and im afrade i am not putting enough fluid in it.it says t20 30 and i was told to put one quort of fluid in it or fill to the...

Hey guys - My very first post - sad to say it's on a maintenance note. Can you suction pump out the T20 fluid or do you have remove the motor and...

just bought a 'Cat, the last one I owned had the Plunger style tranny (I guess it's what you call the borg t-20) this one only has a lever that moves...

While in any gear............. if i'm making a turn from a dead stop, i have to give my argo a couple thousand RPM before it actually hooks up and...

Does anyone know the angle on an 1190, 22,26 or 30 deg.?:hmmmm2:

i got a max 2 that i got and dont have the motor clutch and i got the motor running but now of couse i need the primary clutch let me know which...

ya how do they come off? i got a 1971 trail boss with a polaris 400 twin motor in it any help will be helpfull thanks in advance

does anyone know the size or specs of the shifter orings on a t20 got the plunger sizes from forum but doesnt say the shifter size.

1). What kind of oil should be in the tranny ? 2). With the transmission on the bench when I turn the clutch shaft by hand the power to the idler...

What,if any, are the basics in sizing a belt for a new installation? As far as how it should fit.:hmmmm2: Thanks,Joe

Anyone know how much it would cost to get all the seals and o rings for plungers for the T-20? Are all the seal kits the same regardless of year of...

I just got my t-20 transmission put back together and no longer leaks and everything functions properly. I put my machine up on milk crates today and...

So......whaddya do after an hour or so of useless pounding with a large scewdriver (as your instructions show) to remove a 34yr old T-20 clutch? Keep...

I bought two T-20 plunger adjustment tools from Richard Clark. I slid an ajustment tool between the bolt head and the U channel clip on either end of...

I recently ordered some new bands for a T-20 that I,m going to rebuild. In the package that Recreatives sent me there were two bands marked left and...