Forum: Transmissions

for the first time i just re-built my t-20 in my max IV. must say, as a newbie, it looked harder than it was as so many of you have posted. having a...

can anyone tell me if there is another source besides richard's for purchasing a re-built t-20? thanks for any help

I want to re-inforce my t-20 to my frame. Can anyone tell me how the threaded studs on the t-20 housing can be removed? I don't want to try to force...

I have a comet duster with ribbed cover on my superchief that isnt working properly and I need help! :hmmmm2: Ive been using it since last spring...

Any one know what kind of glue is used to put the pads back on the bands in the Anphicat tranny.

Hi, anyone know off hand how much Mudd Ox charges for break bands, a seal kit and the two bearings for the T-20? Thanks in advance!

I think that I am going to try to rebuild my t20 next spring! I would like to do the popsicle upgrade.my question is where do you find the rings to...

I want to rebuild my 93 t20 with new bands and send the old ones out to be relined. I would like to use the relined bands in my 1980 popcycle stick...

Last month I bought a 1980 maxll. The owner has installed a new 16hp Briggs. I think the belt was from the old motor. I can grab the belt between the...

I have started to tear down my new to me 1980 maxll. I noticed that there are five washers behind the drive clutch. The new 16hp Briggs has an...

Currently out of town! Brought my AATVS note book with me! I am working on upgrading a 1980 maxll. As I was reading about the T-20 I see that I may...

Was just wondering if there are different sources for t-20 bearings. I believe that I have a bad bearing on the drive side of my popcycle t-20. When...

Does anyone have any tricks on how to open the secondary clutch while in the machine? I lost a button somehow. The other two are like new. There's no...

Happy new year to everyone!! Does any one have or know where to obtain the parts manual for the Argo centaur with the hydrostatic double diff? I've...

Moving along with my rebuild. Motor is set to go in soon so now I must turn my attention to the transmission. Until now I have not even given it...

Ok very simple question....... there is a tool that spaces between the adjustment bolt and keepers ... I don't have the tool for the spacing....