Forum: Transmissions

OK, for all of you who have a 69-70 Attex maybe this post can help you out. (where the exhaust exits on the rear of the driver side, not between the...

Here are steps in the first part of the T-20 rebuild. Make sure everything is on a clean surface and that you keep your parts organized. The T-20...

I wrote up a new how-to article on removing and installing the T20 in a Max II. This should be a similar procedure for many T20 machines though so...

T20 Skid Steer Transmission Removal (All pictures can be clicked for a larger view) This article walks you through the steps to remove a...

Skid Steer Transmission Rebuild (Note: All pictures can be clicked for a larger view) A large percentage of 6 wheelers utilized the Borg Warner...

If you have a control stick that is sticky or hard to move it is probably the caliper. Unhook the controls near the caliper and try to move it by...

Hello I have a 16hp briggs and I think I have a primary clutch problem and I,m not sure how to fix it. Most of the clutch movement appears smooth...

I have the older style T-20 with the bars on a pivot pin. When I try to adjust them by the Borg/Warner instrustions, something doesn't seem right....

Hey guys, I have what i believe to be a 78 ' attex 400 chief with the older style t-20 with the 19 tooth gears and slide pin calipers on it. I am in...

After a productive afternoon I thought I would share my success story. I see a few people were looking for new replacement secondary clutches for...

Hi I would like to ID this hydrostatic trans if possible. Can anyone help? Look here for images riotwarrior/Muscateer Trans - Photobucket -...

Read everyone talking about green and red springs on clutches for the T20. Mine has a blue spring. Would that be correct for a Kohler command 20hp on...

I have a 1982 argo with a 17 hp Kohler and a 1190 salsbury primary clutch that is worn. Where can I find parts to rebuild my clutch ? What other...

Hey Guy's; Ive been dormant for awhile, but gettin started for a great sring and summer of ridin'. Pulled the Max IV out of the storage container...

Anyone in the Denver CO area that can work on a T20? I will pay. I have read the article put still no luck. I don't see anything wrong with it. I...

Having just installed my newly overhauled xmission, and installed the driven clutch which i only half disasembled to clean, I now find the running...

hey guys i found a good site for cheeeeeeeepppppp clutches,,,,http://www.apskarting.com/pdfs/190-202.pdf

While my late 70's Argo is down with a broken throttle cable I decided to poke around a little and upon checking the dipstick on the tranny I found a...

how far does the belt supposed to go down in the secondary clutch when you rev the motor in neutral. bob

does anyone make clutches for 4stroke eng.w/1in shaft other thancomet as they are the only ones i can seem to locate.also is it possible to convert...