Forum: Engines

hey friends, the new 21 hp vanguard came with the key switch on the housing. i wired it up to the existing max wires just like the 16 hp was. it...

I've been fighting a vapor lock problem on my 14 hp twin cylinder vanguard that's in a 1970 Argo for a while now. The fuel pump was located right...

Just looking down ebay and came across a few Briggs and Kohlers. Most are vertical shaft and some horizontal. Just wondered if it was possible to...

what i'm wanting to know is whats the differance between the horizontal and verticle briggs besides the obvious and the oil pump. can you take a...

when it rains it pours. all of a sudden my Max IV started running rough. My neighbor said I had "Green gas " in it get it out. It was back firing...

Hey everyone. Your fellow amphibious vehicle lover Mighty MaxIV Has patents on what I believe to be the world's most efficient internal combustion...

Curious to see what jet sizes are being run in the VM38 on a G50B? The one I have is stock with the exception of the. 20 over pistons.

What is a good float height for the VM-34? It acts like it is running out of gas pulling out of pond or steep ditch bank,otherwise runs perfect.(440...

Fellow Owners, I ran across a guy whop has used VMAX batteries and was wondering if anyone else has used them in their 6 x 6 and how did they...

I have a voltage regulator or rectifier that i think needs replaced it has three terminals 2 marked ac 1 marked b+ it is about 4'' by 4'' square with...

I know this has probably been asked a hundred times but on a Briggs and Stratton Vanguard commercial 18 horse how do you measure voltage off the...

Is it possible to test a voltage regulator? Working on a G50B. I have installed a new stator. I get 12 volts at idle and about 12.8 volts at half...

Hello everyone, can someone tell me where i can find a voltage regulator for my 20Amp winding, 18hp brigg... Not counting on the dealer, price is...

has any one tried to but a vw motor in a 6x6 i have a hot rod 2550cc vw motor but dont know how to do it but that might be to much:dontknow:

Posted wanted adds in craigslist. Someone said they had a 1.7l VW motor. Would that fit?

After multiple issues with the walboro wda-1 carb on my max 2 with jlo297 engine I've decided a swap is in order, I have a mikuni tm32 flat side carb...

i have got my hustler going but the i can seem to get the carb right is there any srews on carb that adjust idle or gas air flow it stays running a...