Forum: Engines

I just installed a new carb flange and now my engine is reved waaay up. Which screw is the idle adjustment? 1bbl mikuni on a ta440 kawi motor.

Not the 4 stroke is that loud but I would like to get a bit quieter. Any tips or special mufflers out there?

What do you guys think about the rotax? Do you know how to tell which one I have? Its fast as hell but if you dont start it everyday for some reason...

Has anyone wrapped thier 2 stroke pipes with exhaust wrap tape to help cut down on heat?I have seen this done on 4 strokes but didnt know about 2...

take for example this 25 horse kohler @125 lb 25hp Kohler Engine ES 1-7/16 Command Oil Filter CH730-_ - eBay (item 140207233555 end time Feb-18-08...

Any one know of a good quality Tachometer that will work with the Briggs vangards? I have not had good luck with their "tiny tach" inductive unit; it...

What was the original ratio for the Kohler 440 single carb?The person I bought this off of did not know a lot about the machine?

my 6x6 frontier has about 50 hours on it...i have the escargo tracks on it and i can go through, over, or around pretty much anything but i have lost...

Anybody know what type of electronic fuel injection is used on the Avenger engine? Throttle body, port, or direct? Can't seem to find any...

Max II Engine Replacement This article will act as a basic guide for removing and replacing the engine in a Max II AATV. Before you begin be...

Been thinking about repowering a super swampfox,with a 3cyl suzkui car motor?I found out about this motor from some old posts.4 stroke 3cyl alumimun...

A big thanks to George for sending in several awesome pieces of literature. I just uploaded some JLO wiring diagrams and procedures that he sent me...

I have my 440cc JLO/Rockwell (5 port) twin all rebuilt and ready to go with a fresh .020 over bore with Wiseco pistons installed and I was just...

Here is an excellent pdf chart of Autolite spark plug numbers and plug gap for just about every vintage and modern AATV with every available engine. ...

Posted wanted adds in craigslist. Someone said they had a 1.7l VW motor. Would that fit?

Hi All, I'm new here, I have a 2000 Argo Bigfoot that sat for a couple of years. I've cleaned the gum out of the carb but can't seem to get the...

Well I had to slow down on my aluminum 8x8 build and search for a parts undercarriage for now. I have Xmas and a few other project I have to finish...