Forum: Engines

i have a kohler 440 2 stroke with cdi and just wondering if the cdi unit can be eliminated and replaced with a regular coil(s) ? i dont know that...

I am just cleaning out the engine at the moment, and realized that the oil drain plug is impossible to get to most of the time, so I was thinking of...

Hi All, I don't know if this is already here - I certainly couldn't find it. I have a Max2 with a Kohler Command EFI 29hp motor. It was in pretty...

Hello I have been struggling to get the Sachs motor running in my Amphicat. Not sure what i did wrong but the Plastic ring on the Flywheel cover must...

Has anyone done this? Where did you get the alternator? When I turn on the lights and fan my battery discharges, so I'd like to install an alternator...

Hey all, the title pretty much sums it up. I could use the Ohm specs for the coils if anyone happens to have that information. Thanks in advance!

Hey guys new to this forum but looking for some Advise. I picked up what I think is a 1974 or 79 prairie bobcat with a seized kohler 440 two...

Hi. What are people using for replacement choke cables for engines with Mikuni carbs?

Curious to see what jet sizes are being run in the VM38 on a G50B? The one I have is stock with the exception of the. 20 over pistons.

Hi all, I'm hoping someone has an answer to my problem. I had a brand new carb installed in my ATV and it seemed to run well but began sputtering...

I have a Mikuni 38 mm carb on a Chaparral GB50. It everything works great until I open the throttle up. Then gas starts dribbling out of the...

Some say there are no dumb questions,....I may prove them wrong. What is the top rpm for a stock 16 hp briggs opposed? I have read somewhere 3000 ,...

Hi guys. Quick question. I have installed a 23 hp Briggs in my 91 Vanguard. there has been a lot of comments about the 23 overheating. I have...

I have a Kid 8 wheel drive, ATV manufactured by LTV Aerospace in Tyler, Texas. This unit was purchased surplus in 1969 and is powered by a Wisconsin...

so 2 years ago when i stipped down my argo HDI i had the engine out of it and figured might as well change the coolant.i put prestone cor guard in it...