Forum: Engines

I got a private email from Jordan, but was unable to reply, as his profile is not accepting private emails. Regardless, this may help other folks....

Does anybody know if there is an aftermarket add on kit to install an EFI system on a conquest with the kawi 20hp? It sure would be nice if there was...

Hello just joined and wanted to say hello from the UK. So......Hello from the UK :hello:. I have just bought a 1991 Magnum and its fitted with the...

I have a kohler CH20QS 20 hp engine that I am putting in my Max IV and I am not sure where the wires from the engine connection go. It has a 5 prong...

hey guys just a quick question how much torque would there be on the end of the engine shaft I have a 18 hp briggs to put in my 88 magnum and the...

I was out running my attex and after about an hour of running it wants to stall out. Doesn't seem to be a fuel problem. If I shut it off after that...

Does anyone have any experience putting the Pull start Pawl/Springs back together. I have tried several times, seems to work fine off the engine...

The 16 horse briggs in my 93 argo is starting to sound "loose" and I figure it might be time to look around for a replacement. A 23hp would be great,...

I have a 2 stroke motor in my Max ii, and was wondering if any one runs the over flow from the carb bowl back into the fuel line with a one way valve...

I am just cleaning out the engine at the moment, and realized that the oil drain plug is impossible to get to most of the time, so I was thinking of...

Hey guys new to this forum but looking for some Advise. I picked up what I think is a 1974 or 79 prairie bobcat with a seized kohler 440 two...

Hi guys. Quick question. I have installed a 23 hp Briggs in my 91 Vanguard. there has been a lot of comments about the 23 overheating. I have...

I'm playing with my restoration of a Jiger 152, the original came with dual 5 hp chainsaw engines, changed to a JLO something or other. I picked up a...

Here's my briggs master mechanic friend racing a Tecumseh twin at Talledega. He's in second place 'till near the end. Was geared a little too low...

Hello everyone. I have a JLO 400 and recently found a used vm34 mikuni carb off a honda 400 quad. It seems to be loading up alot. I was curious if...

Any help on this matter would be appreciated. I have been rebuilding a 400 chief over the last few months and finally got it fired up. After...

Hello everyone, IT has been a VERy long time since i posted last. I am still messing with my BIGMAX. I finally have all of the parts to put the...

I found a 30 hp Bandolero engine for $500 on ebay. What I want to know Will it fit in my 1996 argo bf and will my cluch work I have an 18 hp briggs...

Could someone please tell me the crank size of a jlo 440 & will a 30mm and 25 mm salsbury both fit ? Thanks!! both of these clutches are listed on...