Forum: Engines

My buffalo acted funny at start up,like it was trying to lockup.quick ck of the oil revealed over filled,smelled like gas.off to the shop where they...

couple of questions friends. is the bolt threaded into the shaft on a 16 vanguard right or left handed threads ? also when refitting a manifold with...

hey friends, will the 23 hp vanguard fit in my max 2 without any major modifications ? i have the 16 hp in there now and it's time for a new motor. ...

Does anyone know the briggs part numbers for the 20hp carb and intake Im looking to swap out mine on the 18hp

I have a chaparral 6x6 that I believe has a jlo 295 engine in it , but either I am blind or not looking in the right place I can not find anything on...

on the 16 h.p. briggs vanguard in my max 2, the motor shaft i assume is a 1'' x3'' keyed and tapped for a 3/8'' bolt to hold on the clutch. engines...

So I've got my 18 hp B&S at a speed shop getting rebuilt, told them I wanted to at least double the hp...they said it would be no problem. Can't wait...

is there anyway to tell (other than running your argo) if the regulator is broke.i just replaced the fuse but waiting for next year when i use it to...

I was wondering if a carburetor comes pre adjusted from the factory when you buy new! Finally going to change out the single to a double barrel carb!

Compression 110psi, New Carb. 14-16 Kohler, Great spark, Good key in flywheel, Starts and runs on Starter fluid and then runs crappy until warm....

Hi, I've got a 2009 Avenger and I recently encountered an issue while attempting to start it: when I turn the key to the start position, the starter...

Ive got a bad oil leak on my 99 Response. It appears to be on the side of the engine with the pull start. I cant find the leak and before I start to...

we have a 1972 sears sportster 6 wheeler(the kind the banana splits rode in,lol). it has a JLO Rockwell 2 stroke engine. was wondering if anyone may...

hi, i have a 1992 argo magnum with a kohler m18 engine. the machine runs perfect and is a great rig for what i use it for.after my grandfather...

i was wondering how to clean a carb on a kohler 18 hp magnum. the engine is red.thanks!!

I have had it with the POS carb on the 18 hp Vanguard in the green Attex. Its time to upgrade to a mikuni. Anybody attempt this yet? Anyway I will...

im running 18 hp on a frontier with adair tracks. its hard to turn in low gear and really difficult in hi gear. any recommendations???

Does anybody know how to check to see if the charging system works on a JLO 300 engine? My harness was hacked up so I have 2 yellow wires that come...

Finally back on the project after a 4 year pause. Finished assembling 3 new sprockets and mounted the all axles. T20 rebuilt and back on chassis. ...

Rebuilt B&S 18hp (#421437-013601) will not start. I am not getting a spark across the plug but I do if I remove the plug and arc the plug wire to...