Forum: Engines

Hey guys. I went out to take my 1988 Argo for a ride last night, and when I went to throttle it, it just bogged, it didn't have enough power to turn...

Hey Guys, new here to the forums, found you from a google search. Ive got a argo conquest that sat for a while and gummed up the carb. I took the...

Can anybody tell me The Briggs stratton part # for the governor spring black its the one that gos to throttle and governor argo part #805458. A...

so I bout 2 coils to replace mine,lost spark on the right lung. Can anybody tell me the correct wiring for the coils?!?!? thanks once again guys

Was wondering if I wonted to get a little more hp out of my 16 hp Briggs what would be the easiest way to get it or can this even be done?

ok got a duromax 4 stroke engine, still lookin for a clutch does anyone know and have some pics on how to set up a trhottle on these? the factory one...

ya ya i know,4 wheelers are the enemy lol.my poor old honda foreman has an electrical issue.starter wont turn engine over unless i jump the...

I have a problem with my starter. It runs in reverse. Thats with the positive hooked to the positive and ground to ground. Im bench testing it. The...

Looking to see if anyone has had this problem? I installed an 18 hp Briggs in a Max 11,, I started the engine and run it for about 2 minutes, just...

Could anybody tell me the shaft size of a Kohler CH20. Are the shaft sizes all the same or do they vary depending on application? I'm looking to get...

Ok guys, here is the build to deal with how to adapt a snow machine clutch to the flex plate. You will need 1. a good machinest machinest 2....

Hi Guys, My Max II has a 16 HP vanguard that wants to run rough and surge and almost stall unless I give nearly full throttle. It seems to happen...

I have a 24 hp Honda motor with a Salsbury centrifugal clutch does anybody have the number to the company Salsbury or know what belt is supposed to...

Hello everyone, I've got an 18 HP Vanguard v-twin. Governless,high rev kit with timing advance key, modified stock exhaust and K&N air filter....

Hi, I was wondering if anyone can give me information. I saw a Kawasaki 25 h.p motor from a John Deere Z Trac for sale for $500, and was wondering if...

Looking for ideas or proven plans on fitting the B&S on the motor plate of my Max IV. Bolt pattern is different, B&S is much wider than the Kawi. ...

Rebuilt B&S 18hp (#421437-013601) will not start. I am not getting a spark across the plug but I do if I remove the plug and arc the plug wire to...

Compression 110psi, New Carb. 14-16 Kohler, Great spark, Good key in flywheel, Starts and runs on Starter fluid and then runs crappy until warm....