Forum: Engines

Hey Guys, new here to the forums, found you from a google search. Ive got a argo conquest that sat for a while and gummed up the carb. I took the...

Can anybody tell me The Briggs stratton part # for the governor spring black its the one that gos to throttle and governor argo part #805458. A...

so I bout 2 coils to replace mine,lost spark on the right lung. Can anybody tell me the correct wiring for the coils?!?!? thanks once again guys

have redone this motor new gasket kit installed we got it to start then turned it off wont start seems to be blowing gas out carb need help ...

Hello, I've been trying to fix a spark problem on a jlo 399. I have spark on one side but not the other. When i put new plugs in I did get spark...

Was wondering if I wonted to get a little more hp out of my 16 hp Briggs what would be the easiest way to get it or can this even be done?

I am having trouble with the starting/choke system in my attex. It is a jlo399 with a vm32 carb. My trouble is the choke doesnt work at all.I...

ok got a duromax 4 stroke engine, still lookin for a clutch does anyone know and have some pics on how to set up a trhottle on these? the factory one...

ya ya i know,4 wheelers are the enemy lol.my poor old honda foreman has an electrical issue.starter wont turn engine over unless i jump the...

I have a problem with my starter. It runs in reverse. Thats with the positive hooked to the positive and ground to ground. Im bench testing it. The...

Looking to see if anyone has had this problem? I installed an 18 hp Briggs in a Max 11,, I started the engine and run it for about 2 minutes, just...

Could anybody tell me the shaft size of a Kohler CH20. Are the shaft sizes all the same or do they vary depending on application? I'm looking to get...

I have a single cylinder Rockwell JLO 396cc engine that I'm getting ready to overhaul. I'm going to need a piston, rings, gaskets, crank seals,...

I was wondering if some one had all the specs for the carb main jet, pilot jet,jet needle,needlejet,throttle valve, and needle and seat size. Thanks!!

Today I stopped at a small gas engine equipment shop to see about getting a new 18 HP Briggs & Stratton Vanguard for my Max II and was told that I...

Hello everyone, I've got an 18 HP Vanguard v-twin. Governless,high rev kit with timing advance key, modified stock exhaust and K&N air filter....

Hello Everyone, I've got a 1997 Bigfoot that seems to have a fuel starvation problem only going up forwards on steep inclines. It did it with my...

Okay, here is the story. At the last race (last month) I rolled my machine over. Before that it ran fine. When I went out for the next race I got...