Forum: Engines

I have a b&s 16hp twin & and a 16hp kohler single k341qs model. The kohler is in the hustler now and runs great. Should i put the b&s 16hp in the...

Just picked up a 1989 6 x 6 argo with the 16hp tecumseh engine. Originally it started fine, but the idle was set so high that the twist throttle was...

My max 2 bogs down and stalls whenever i give it gas and put it in gear. in neutral i can rev it all day long but when i put load on the motor it...

Does any body have a wiring diagram for the Attex wiring harness? I am trying to find out which wire in the ignition switch turns the engine off. I...

Does anyone have a wiring diagram including the wiring harness for a attex chief. I would like to have the diagram for future reference. The engine...

I'm looking for a good used carb for my stock JLO 440 if anyone has one for sell. I have the stock carb and I think it is a 30mm or 32mm flange...

What is the proper compression range on a JLO 440 ? Mine has 215lbs PTO and 180lbs clutch while cold. Is this too much difference between the...

I have a JLO 440 and have bought some 5 port Cuyuna 5 port cylinders with 6 bolt Heads that came with the pistons, intake and exhaust. Everything is...

just got it and have no spark any help would be great a engine repair manual would b awesome! funny thing me buying an amphibious as i live in the...

Hey folks, I've seen a few posts lately about alternators. I've been testing a new rectifier regulator for the last couple of months that may be...

2003 MAX IV ordered a new starter ignition switch for my dad's 6x6 but the old pigtail was shot so i had already cut it off thinking i was just...

I just bought a 70s 6x6 Argo with new tires new chains new every thing pretty much. but when I put the original engine back in it (440 Kohler) the...

Im looking at buying a 16hp vanguard that came off a generator the guy says it has a 1'' shaft ,stator and electric start only, would that be an easy...

does anyone know where the points are on a old 440 kohler? it doesnt have the external box near the bottom of the motor like some do are they...

has anyone ever used the liquid gasket stuff (u know the stuff at autozone)for a intake gasket?

anyone have any tricks to holding the clutch to remove the pully bolt on the other side of a 440 kohler?, I need to replace my points and can get...

I just traded my kohler 17 hp for a jlo 399 and a rotax 399 ,they both run, heres my problem, how do I kill the jlo? its pull start only and theres a...