Forum: Engines

Hey guys. I went out to take my 1988 Argo for a ride last night, and when I went to throttle it, it just bogged, it didn't have enough power to turn...

Hey Guys, new here to the forums, found you from a google search. Ive got a argo conquest that sat for a while and gummed up the carb. I took the...

I know this has been done many times, but I'd like some pointers as to where to start. My 04' Max IV has all the power you need about 90 percent of...

so I bout 2 coils to replace mine,lost spark on the right lung. Can anybody tell me the correct wiring for the coils?!?!? thanks once again guys

Was wondering if I wonted to get a little more hp out of my 16 hp Briggs what would be the easiest way to get it or can this even be done?

ok got a duromax 4 stroke engine, still lookin for a clutch does anyone know and have some pics on how to set up a trhottle on these? the factory one...

I have a 1999 Max IV with a electric start with a back up pull cord 16 hp Vanguard. How much SAE 30w oil does it take? What kind of oil filter? Where...

I have a single cylinder Rockwell JLO 396cc engine that I'm getting ready to overhaul. I'm going to need a piston, rings, gaskets, crank seals,...

I was wondering if some one had all the specs for the carb main jet, pilot jet,jet needle,needlejet,throttle valve, and needle and seat size. Thanks!!

hey all I have a kabota v1505 turbo deisel in my predator and my temp guage is acting goofy. The temp sensor is located in the housing right near the...

Today I stopped at a small gas engine equipment shop to see about getting a new 18 HP Briggs & Stratton Vanguard for my Max II and was told that I...

Hello everyone, I've got an 18 HP Vanguard v-twin. Governless,high rev kit with timing advance key, modified stock exhaust and K&N air filter....

I have a 14hp Vanguard and the springs/linkage is missing or all bent up on the carb/governor. Does anyone have a decent closeup pic of the carb...

Hope this is the right thread for this, couldn't find an electrical thread. I am trying to figure out the proper fuse size for my push button...

Hi guys, Picked up a MAX II with the round headlights (I believe that model has some designation, Big something?) that was in need of a lot of...

I have a Kohler Command 18. I need Crank seals for it and V,cover gaskets. Where is the best place to get these ? Thanks Guys! Tj

Hi All I have a issue with my 18hp Vanguard and I will try my best to put all info in the post. 1. year 2000 vanguard 18hp 2. year 2000 max II 3....