Forum: Engines

I am fixing up an old argo it's my first experience with one. I think it's about 1984 . It has a tecumseh oh180-180017c It starts up and runs but...

hello my name is mason i just purchased a 1970 seirra trail boss it has a kohler motor model# k295-1st it is a 2cycle motor it has good spark 150psi...

I just got a new (old) Trackster and it just doesn't want to run. I replaced the plugs cleaned the fuel system and cleaned the carb. It has the...

yo guys i have a flat spot in my engine its a rockwell jlo when i give the engine gas by pushing in my throttle the engine bogs out n dies the...

I have a 1989 max ii with oh160 engine. In November I picked it up in Minnesota and drove the 12 hours home. When I picked it up we checked for...

I finally got my new 23 hp Briggs and Stratton Motor. NOW, I'm confused (which is normal by the way). My new motor has got the Key on the side of the...

I'm rebuilding my jlo 440 & my brain can't remember removing the old seal. when installing the new one does the flat side go in facing the crank or...

Anyone have a wireing diagram for the 20hp Kawi? I have the engine yanked out, and the new 27HP ready to go in, but the wired plug is not done the...

I got a private email from Jordan, but was unable to reply, as his profile is not accepting private emails. Regardless, this may help other folks....

I have a 1999 Max II with 150 hrs. on it. Machine has a 18 hp. When going to turn key sometimes I have to turn once or twice for engine to start....

Hello, A friend gave me this motor when I told him I was looking for a power plant for a small mill I'm building. I've researched it a bit; first...

I have a vanguard 18 hp in my hustler machine and was wondering if anyone knows if they have a different jet for high altitude operations.

Just found a net kohler web site. Its called www.midwestsupercub.net They have some 25hp kohler motors putting out 80hp.That would make one heck of a...

I am not sure if this has been gone over yet but has anyone put a high rev kit in a briggs 18 horse vanguard mine works fine but I want to go faster...

Hi, just put new gaskets in this carburetor. Its on a JLO 252 in a Terra-Tiger. I've poured gas in the line and it will run by that. stuck the...

I'm putting the sc's motor back together and cant seem to find the specs for the engine bolts...anyone? crankcase,cylinder base, head bolts, etc....

The exhaust on the Max IV was whipped and, I always wanted to try to make my own exhaust. I wanted it to be as quiet as possible and still allow...